资源列表
dht11rs232
- 湿度传感器DHT11和MCU的RS232通信和数据传输-Communication between humidity sensor DHT11 & the MCU using RS232
8-digital-tube-rolling-display
- 这个程序是学习单片机很好的入门程序,是入门必学的好程序。-The program is learning microcontroller nice introduction program, is an entrance will learn good program
OPENDOOR
- 自动存包柜的几个功能模块程序。这个是驱动电磁铁开门的程序。-Automatic deposit packet counters, function block.
StepMotor
- 这是一个关于简单的单片机控制步进电机的代码.它是基于STC89C51芯片的，实现一些步进电机基本的控制，正反转，暂停，快进....一系列步骤-This is a simple SCM stepper motor control code. It is based on the STC89C51 chip, to achieve some basic control of stepper motor, reversible, pause, fast forward ... A series of
liushuideng
- arm中用C编写的流水灯程序，已经测试成功-arm using written in C light water program has been tested successfully
myproject
- 串行数据处理程序，将rs232数据转换成为sdi数据输出。-sio program .convert rs2323 to sdi data.
STM8S103_watchdog
- STM8S103_的独立看门狗的超时复位-the STM8S103 s watchdog operation
pulsedelay
- c51单片机常用子程序延时(12MHz晶振,1s,10s... )-delay subroutine (12MHz crystal, 1s, 10s
uart
- 51单片机通过串口接收发送数组的c语言代码
16sw10
- 单片机数码管显示16进制<->10进制互换程序
16to10
- 16进制to10进制输出子程序:显示数据，起始位，结束位，有无小数点-16 to10 band-band output subroutine : display data, the starting place, at the end, there decimal point
Driver_UART.rar
- C8051F120 UART 完整程序 ，自己编的， 测试通过,C8051F120 UART complete program, its compilation, and test