资源列表
51ADC0809
- 51单片机控制ADC0809芯片实现模数转换，并将结果用数码管显示-51 SCM ADC0809 chip ADC, and the results with digital display
Seg7Code
- 双数码管可调秒表，，选用12MHz的晶体。为了达到精确计时，选用定时器方式2，每计数250重载一次，即250us，定义一整数变量计数重载次数，这样计数4000次即为一秒。定义两个字节变量S10和S1分别计算秒十位和秒个位。-Dual adjustable digital stopwatch,, use 12MHz crystal. In order to achieve accurate timing, use the timer mode 2, one for each count of 25
nfadfa
- This a c program that converts NFA to DFA-This is a c program that converts NFA to DFA
12864
- 凌阳61板单片机驱动的串口12864程序。经过试验是有效的-Sunplus driven serial 12864 procedures
LED-one-second
- 飞思卡尔芯片，控制发光二极管间隔一秒发光与熄灭，适合初学者-Freescale chips, control LED light and extinguish one second interval, suitable for beginners
lesson5-3
- 51单片机控制矩阵键盘，消抖，适合初学者，注释详尽-Matrix keyboard control
keylight
- 基于8051的键盘开发，内部有详细说明，适用于入门8051的新手。-Based on the 8051 keyboard space development, internal details, for the novice entry 8051.
4051
- cd4051芯片驱动,定义管脚后可直接调用输出接口，输出值以在头文件中给出-driver for cd4051
shumaguan
- 基于51单片机的基本计算器，实现基本四则运算-51 single basic calculator
PWM
- 通过PWM（脉宽调制）调节LED的亮度 定义 LED到P1.0端口 改变led循环中的延时量实现调光-Through the PWM (pulse width modulation) adjust the brightness of LED definition LED to P1.0 port change amount of delay in the LED loop to achieve dimming
1
- LED循环左移, LED循环左移-LED cyclic shift leftLED cyclic shift left
DINGSHI
- 使用定时器的定时中断，根据硬件电路编程实现一个计数器，使之从0开始以1秒的速度以十进制加1计数，并在数码管上显示出来。-Timed using a timer interrupt, to implement a counter based on hardware circuit programmed to start at a speed 0 to 1 second plus 1 count in decimal, and displayed on the digital tube