资源列表
controlsystem
- 基于PIC单片机的液压控制系统的小程序，用C写-PIC microcontroller based on the hydraulic control system of small programs, written using C
12864
- microchip单片机控制lcd12684液晶显示程序-microchip MCU lcd12684 LCD program
stcEEPROM
- STC单片机，EEPROM操作 IAP_Disable //擦除扇区, 入口:DPTR = 扇区地址 void Sector_Erase(UINT add) 读一字节 字节编程-STC microcontroller, EEPROM operation IAP_Disable// Erase sector, entry: DPTR = sector address void Sector_Erase (UINT add) read a byte byte programmin
TLC5615
- TLC5615 10位精度 可以用来信号发生器-TLC5615 10 precision can be used to signal generator
LCD-display-character-type
- 本文介绍了再visual C++环境中的LCD显示设计 且设计的类型为字符型显示。可以运用到proteus的设计中-This article describes the visual C++ environment, then the LCD display in the design and the design of type character display. Can be applied to the design of proteus
PIC-uart
- pic单片机编程开发 主要与uart有关-Programming uart pic microcontroller
yjxs
- 单片机开发液晶显示程序1602大家可以互相参考参考 -1602 LCD MCU development program we can cross-reference information
fet140_adc12_05
- TI msp430 licheng chengxu05- TI msp430 licheng chengxu05
10-3
- 基于8051单片机的ad芯片测量电压的程序-8051 ad-chip measure the voltage-based program
Motor-Control
- 电机转动控制程序，基于AVR单片机，用于POV旋转时钟的电机控制-Motor rotation control program, based on the AVR microcontroller, for the POV rotate clock motor control
dianzhen
- 实验名称：点阵式LED“0－9”数字显示示例程序 程序说明：用跳线帽短接J2的左端，选通点阵管，烧好程序，就可以看到点阵管依次显示“0-9”这10个数字。-Experiment name: Dot Matrix LED " 0-9" digital display sample program Program Descr iption: The jumpered left side of J2, strobe lattice tubes, burned a good pro
STC12C2052AD-AD
- STC12C2052AD-AD 可实现一路AD数据采集-STC12C2052AD-AD AD data acquisition can be achieved all the way