资源列表
shizhong
- 时钟电路的C语言程序，与单片机连接正常显示，这是我们实训的程序保证能用-Clock circuit C language program, normally connected with the microcontroller shown, this is our training program guaranteed to
main
- 51单片机的数码管动态扫描，用C语言编写，可以设置时间。-51 MCU digital dynamic scanning, using C language, you can set the time.
ServoCon
- 一段关于舵机的控制程序，可以控制舵机的启动停止-failed to translate
motor
- 本段 程 序是关于介绍关于步进电机的程序-This section of the program is a program for presentation of the stepper motor
Uart0
- 基于MSP430F149单片机的串口0驱动程序-MSP430F149 microcontroller-based serial port 0 driver
89s52CX-(2)
- 51单片机89S52的程序控制模数转换器AD0809和数模转换器DA0832-51 microcontroller 89S52 program control ADC AD0809 DAC DA0832
D-A2
- 能实现数模转换，随着数码管数值的变化，LED渐亮-Digital to analog conversion with the digital control value changes, the LED fade
jiajiansu
- 单片机步进电机正反转c程序，有需要的朋友可以拿去参考一下-C program, single-chip stepper motor reversing a friend in need can have it for reference
bujindianji
- 本程序为单片机的c语言源程序，可以实现通过单片机控制步进电机的加减速。-This procedure for microcontroller c language source code, can be achieved through the SCM stepper motor control acceleration and deceleration.
si7021
- SI3072 温湿度传感器芯片的驱动程序-SI3072 temp&&humi chip driver
jianbian001
- 本程序可用于LED灯饰或舞台灯的方案设计。-this procedure can be used for LED lighting or stage lights program design.
xunji2
- 采用KEIL51编译,并在自己制作的板上运行过,具有很大的实用性