资源列表
ad-da
- 一个简单的利用单片机进行AD DA转换的程序，希望对初学者有所帮助-A simple microcontroller AD DA conversion program, I hope to help beginners
led
- 利用 SPCE061A 单片机和 LED 点阵显示模块，来设计点阵显示的硬件电路，并编制相应程序，实现中文字符的显示。编制键盘扫描程序,将键值显示在 LED显示器上。-Use SPCE061A microcontroller and LED dot matrix display module to design the hardware circuit dot matrix display, and the preparation of the corresponding procedures,
seg
- 用汇编语言编写的8位数码管程序，是德飞莱板子的测试程序，很好用-Written in assembly language for eight digital tube procedure is Defei Lai board test procedure is useful
28BYJ
- 基于STC89C51单片机的步进电机驱动程序，步进电机采用28BYJ的四相五线步进电机，驱动芯片采用ULN2003，通过检测电平可实现步进电机正转反转。-STC89C51 microcontroller based stepper motor driver, stepper motor with 28BYJ four-phase five-wire stepper motor driver chip ULN2003, the detection level can be achieved by
delay
- 利用stm32f407作为测试板，作用为利用TIM3定时器和中断服务来进行精确的延时，进过测试可以精确到3us，如果延时时间小于3us会造成比较大的误差。-Stm32f407 use as a test board, the role for the use of TIM3 timer and interrupt service to perform accurate delay, been to test can be accurate to 3us, if the delay time is
lowpassFIR
- matlab上实现的FIR低通滤波器的代码范例-Sample Code implemented on matlab FIR low-pass filter
WK
- 基于单片机的温度控制系统。只是一个比较简单的教程。教学中的运用-Temperature control system based on single chip microcomputer. Just a relatively simple tutorial. Teaching use
TLC2543
- 12位ad2543的程序，已经调试过，可以用的
ISR
- 单片机串口程序模块.. 发送数据区数据
max542DAC8532
- 本程序是基于MAX542 16位DA的程序，以及DAC8532 DA的程序-This procedure is based on the MAX542 16 bit DA procedures, the use of profile!
liushuideng
- 流水灯学习程序，方便各个初学者学习，需要请下载。-liushuideng
led.1
- AT89C51单片机控制16*64led的静态显示。16*64LED是由16片8*8的LED 组成-AT89C51 microcontroller control 16* 64led of, static display. 16* 64LED 16 8* 8 LED