资源列表
testseri
- 51单片机用T2做波特率发生器实现115200波特率串口传输程序。-51 SCM done with T2 115200 baud serial port baud rate generator to achieve transfer program.
lcd
- 利用msp430f427控制断码液晶，使其可以显示“6543210”。-LCD broken code using msp430f427 control so that it can display " 6543210."
stepMOTO_c51
- 一个步进电机单片机控制程序，有电机正反转及加减速控制。
PWM
- 5110的显示程序 该程序时基于飞思卡尔16位单片机的显示程序-display for 5110
PIC16F1937-MCLR-KEY
- MICROCHIP PIC16F1937 MCLR-KEY 测试程序，亲测可用，源码出处文件内已声明-MICROCHIP PIC16F1937 MCLR-KEY testing procedures, pro-test is available, the source file has been declared within the source code
zhinengxiaoche
- 2014年山西省电赛智能车程序源码，利用步进电机完成固定路径的巡查-2014 Shanxi electric smart car race program source code, the use of a stepper motor to complete inspections of fixed path
STC12c5608
- STC单片机读写ADS1110,iic读写，调试成功-STC microcontroller to read and write ADS1110，iic read and write, debug successful
Light-water
- 利用msp430单片机的定时器timeA定时产生中断，在中断中按顺序依次点亮led灯，结束后，再依次熄灭led灯。-Use msp430 microcontroller timer timeA timer generates an interrupt, the interrupt led lights lit in sequence, after the end, and then turn off led lights.
C8051F020
- c8051f本测试程序用来测试板上所以I/O连接状况 外接LED共阳数码管 实验时将跳线帽接至+3V-c8051f the test procedure used to test the board so the I/O status of external LED anode connected digital tube experiments, the jumper connected to+3 V
CC1100-315MHz-433MHz-Design
- 基于STC的CC1100软件驱动，发送程序部分。-STC-based CC1100 software driver, send the program part.
PS2
- 这是avr单片机ps2接口驱动程序，很好很实用的，也是很稀少的资料，在此分享给大家-This is the avr microcontroller ps2 interface driver, very good very practical and very sparse data, for everyone to share in this
16bit-Flash-erase
- 16位Flash擦除烧写程序 16位Flash擦除烧写程序-16bitflash erase program 16bitflash erase program