资源列表
ourdev_598678PTMEFK
- 串行FLASH_W25X40_读写程序范例。。立即可以使用哦-Serial read and write FLASH_W25X40_ procedures example.. Immediately you can use the oh
pelco-Dcpp
- Pelco_D协议的单片机的云台控制代码-SCM Pelco_D protocol PTZ control code
Experiment-no-7
- This program is written to construct a digital clock using timer in AT8051 microcontroller
8255
- 基于AT89S52和8255的并行口扩展程序，程序注释清晰，只占用单片机8个IO口即可扩展24个-AT89S52 based on the parallel port and the 8255 expansion program, the program notes clearly, only takes single-chip 8 IO ports can be extended 24
UART_MSP430G2253
- In this application a DS18B20 communication with MSP430G2452. All hardware library is included.
jianpanshumaxianshi
- 适用于单片机ARM等控制器的键盘程序，简单易懂好使，可以读出键值供数码管显示，通用4*4键盘C程序-Applicable to single-chip ARM controller keyboard and other procedures, so easy, you can read out the key for digital tube display, GM 4* 4 keyboard C procedures
Project-V2-circuit-diagram
- Circuit diagram of Project V2
MAGE8ADC
- AVR芯片中的ATMEGA8芯片的ADC程序，并带有数字显示。-AVR chip ATMEGA8 chip ADC procedures and with the figures.
Digital_sequence_845
- 基于ADuc845的数字序列发生器，串行连续输出，可接8位并行输入-ADuc845 based on the number sequence generator, serial for output, which can be accessed by an 8-bit parallel input
DportRAMComm
- 在双口RAM的8051单片机之间的通讯，数据传输与接收。-Communications, data transmission and reception between the dual-port RAM 8051.
led
- 利用AVR单片机的I/O口来实现LED的亮灭
stopwatch
- 按键控制秒表，数码管显示，中断控制，中断0控制计时和停止，中断1清零,用导线连接GND-Button control stopwatch, digital display, interrupt control, interrupt the 0 control timing and stop interrupt cleared with a wire connected to GND