资源列表
Infrared-decoding-digital-display
- 遥控器红外解码数码管显示，按配套遥控器上1-9会在数码管上对应显示-The remote control IR decoding digital display, press 1-9 on supporting the remote control corresponding digital tube display
pcb
- 基于测直流电机的速度和速度的控制；； 所需的PCB原理图-speed of motor by 51
2195b1_1
- M25PE10, M25PE20, M25PE40 and M25PE80 这些型号FLASH 的驱动程序
DS1302
- DS1302源码 STC89c52单片机控制-DS1302 Source STC89c52 SCM
dianweiqi
- 数字电位器，基于单片机可调节电位器电阻值-digital resistance
LABD2
- Developed for use with MSP430x22x4 MCU (2274). Made with Code Composer Essentials v3.1. VLOCLK used, MCLK from VLOCLK.Also calibrated DCO s used. Basically this file is for educational use working with Basic Clock Module+. Timer interrupts used fo
MAX7219
- 基于MAX7219的8位数码管理显示（带电路图）MAX7219 8-bit digital-based management of display (with circuit diagram)-MAX7219 8-bit digital-based management of display (with circuit diagram)
da
- DAC7512与51单片机通信的C程序，仿真是正确的-C program of the DAC7512 and 51 single-chip communication, the simulation is correct
RTC
- real time
驱动
- 用Keil C51写的步进电机驱动程序。-Keil C51 was made with the stepper motor driver.
5IO_TO_15KEY
- 使用5个IO口来扩展15个按键，附原理图及源代码，51仿真。
arm1
- 用于atsam9261开发版的led程序，完整打包整个工程文件可在ads1.2下打开，已经在实验板上烧写，正常运行-at91sam9261EK led