资源列表
Real-timewithacommonanodeLEDdisplayADc0809value.ra
- 用共阳极数码管实时显示ADc0809的值，（除去数码管‘位选’接法需要自己接驱动三极管外，其余电路部分均参照protuse图中接线）虽然protuse中没有效果，但程序经实物调试绝对可用-Real-time with a common anode LED display ADc0809 value, (excluding digital ' Choice' connection needs its own access driver transistor, the remainin
MyCLCK
- 430的时钟设置模块，可选择时钟，可以输出测试时钟-430 clock settings module, selectable clock output test clock
420mATransmitterforRTD
- rtD PT100 CONDITIONNING CIRCUIT
14_ADC12TEMP
- 12位ADC显示，适用于MSP430单片机，适于初学者-12-bit ADC show for MSP430 microcontroller, suitable for beginners
PwmStepmotor
- 步进电机控制程序，可以进行加速减速控制，并用1602显示器显示。-Step-Motor template based on 8051-Mcu.
usbto232
- 232转USB硬件接口图，KETL下的源代码，完全能用的HEX，原理图。-232 switch to USB source code, HEX, schematic diagram.
LED
- MSP430F1611单片机的流水灯控制程序代码，可以下载直接调试。
dingshihezhongduan
- 定时中断程序，用的是MC51的单片机，软件是Keil,一般在开发板应用。-Timer interrupt program, using a MC51 MCU software is Keil, the general application in the development board.
use-MCU-tocontrol-Potentiometer-
- 数字电位器与单片机接口代码程序，包括电路，数字电位器资料。-the way to use MCU to control potentiometer
123
- 单片机控制电机的两个程序，包括电机的停止控制程序，电机的正反转-Microcontroller controls the motor of the two procedures, including control procedures to stop the motor, reversing motor
Smpl_DrvSPI
- 这是CORTEXMO的SPI通信程序，使用的是新唐生产的芯片 -This is CORTEXMO the SPI communication program Nuvoton chip production
countdown-timer
- 51单片机开发程序。实用99分钟倒数计时器-51 microcontroller development program. Practical 99-minute countdown timer