资源列表
The-single-chip-control-LED-display
- atmega16单片机控制数码管显示矩阵按键值-The single-chip control LED display matrix key value by atmega16
51DDS
- 用51单片机模拟dds产生正弦波，方波，三角波，幅度频率可控。-Dds generated using 51 MCU simulation sine, square, triangle wave, amplitude frequency control.
wg34
- 韦根26标准就可以容易找到,但韦根34标准不好找.齐齐分享.让中国电子行业飞速发展.-Wiegand 26 standard can be easy to find, easy to find but Wiegand 34 standard. Mouths to share the rapid development of the Chinese electronics industry.
CDPJ01
- 单片机实现RS-485总线现场监测系统 含C程序工程文件及电路原理图-Single-chip implementation RS-485 bus system with C-site monitoring procedures for engineering documents and circuit schematic diagram
F340_i2c
- c8051f340的IIC应用程序，包括底层初始化，端口输出控制，时序控制等源程序-c8051f340 the IIC applications, including low-level initialization, the port output control, timing control source
AD
- C51RFPS开发系统，cc1110无线收发模块，ADC应用程序。-C51RFPS system,cc1110 basic application,ADC.
EM78P_SPI
- EM78P153做的测试治具：用到74HC595，完整工程的SPI程序，架构清晰，初学者必看。-EM78P153 to do the test fixture: used 74HC595, the complete works of SPI program, clear structure, must-see for beginners.
SXtemper
- c8051F330单片机温度闭环pid控制系统程序，keilc环境，软件实现了单片机控制的发热电阻温度在设定值-c8051F330 SCM temperature closed-loop pid control system programs, keilc environment, the software enables the MCU to control the heat resistance temperature settings
123456
- 用于检测单片机开发板，操作方便，应用场合广-MCU development board used to detect, easy to operate, wide applications
AD7682_TEST
- avr上的 ad7862驱动，很容易看懂的程序，采用的是 GCC编程，-avr on ad7862 driver, it is easy to understand the process, using the GCC program,
alar
- 转为ATM设计的自动报警程序，当ATM机有报警信号是，本系统将向报警中心发出报警信号，同时将本地实时视频画面传至报警中心，并接通本地与报警中心通信。-Converted to the the ATM design of automatic alarm program, when the ATM machine alarm signal, the system will alarm center to send an alarm signal, while the local real-time
logic
- 1.逻辑电路图中至多有100行，每行至多有100个字符。 2.电路走向在交叉点转90˚ ，其余部分沿直线传播。任意 两个交叉点都不相邻（竖直方向和水平方向）。等条件的电路的c++程序 -1. Logic circuit in up to 100 lines, each line of up to 100 characters. 2. Circuit toward the cross-point switch 90