资源列表
przerwania
- AVR atmega 8 tools for interrupts
34324
- 这个呢，无线发送接受的程序，也不错哟，相当适用，供大家参考-This does, wireless sending accepted procedures, not bad yo, quite applicable, for your reference! !
8051-with-Memory-Mapped-LCD1602
- LCD1602驱动内存映射的1毫秒的延迟调整为12MHz的时钟- LCD1602 Driver Memory mapped Delay of 1 milliseconds- adjusted for 12MHz clock
chaoshengbo
- 51单片机超声波测试程序，精度0-4米，有详细说明，定时器使用中断等设置。-51 single-chip ultrasonic testing procedures, accuracy of 0-4 meters, a detailed descr iption of the timer to use interrupt set.
51Timer
- 51定时器程序，本程序采用STC89C51单片机，请修改相关设置-51 timer program, the program uses the the SCM STC89C51, modify the settings
pulse_a
- 利用定时器控制单片机iO口输出特定频率的波形-Using the timer control MCU iO port output waveform of a specific frequency
tea5767_3wire
- Tea5767的3线控制程序，M8单片机，采用3线控制，内有电路原理图，可手动指定频率，也可以上下搜索
PCF8591-ADDA
- 使用4路AD中的1路检测外部模拟量输入，显示0-255数值,DA输出电压用LED显示，主要用于检测环境光线，光线强，则灯亮度小，以保证整体光强稳定在一个范围,这种思路和用法主要用于自动调光，可以根据环境亮度自动调节，从而达到节能最大化-4-channel AD Road detect external analog input display 0-255 numerical DA output voltage of the LED display is mainly used to detect
AD2
- 程序功能：MCU的片内ADC对P6.0端口的电压进行转换将模拟电压值显示在1602液晶上。-Program features: MCU on-chip ADC for converting the voltage P6.0 port analog voltage value is displayed on the LCD 1602.
AT24C02
- 该程序是基于STC89C52的AT24C02掉电存储程序，测试通过，程序I/O口需用户自行配置。-The program is based on the STC89C52 AT24C02 electricity stored program, through testing, process I/O port users will make their own configuration.
xunhuanzuoyi
- led灯循环左移c程序 在四个字节之间循环左移 编译器iccavr-led lights rotate left the compiler iccavr c program cycle left between the four bytes
SMBus
- This example demonstrates how the C8051F06x SMBus interface can communicate // with a 256 byte I2C Serial EEPROM (Microchip 24LC02B). // - Interrupt-driven SMBus implementation // - Only master states defined (no slave or arbitration) // - T