资源列表
ADS7883
- 关于TI公司的ADS7883完整源程序，可直接使用-code about the ADS7883
243265676
- 很简单的12864驱动程序，用at89s52控制的，自己写的 -12864 driver very simple, with at89s52 control of their own writing
time-clock
- 时间中断溢出触发方法制作的带2闹钟的可调时闹钟时钟-Time interrupt adjustable overflow trigger method produced with 2 alarm clock alarm clock when
shanshuodeng
- 如图4.1.1所示：在P1.0端口上接一个发光二极管L1，使L1在不停地一亮一灭，一亮一灭的时间间隔为0.2秒。 -As shown in Figure 4.1.1: the P1.0 port by one light-emitting diode L1, L1 to keep a light in one off, a light one off the time interval of 0.2 seconds.
src
- EMD（经验模态分解）的C语言实现程序，调试后可用-EMD (EMD) of the C language program
STC12C5A(20)
- STC12C5A例程(20)-触摸屏驱动 STC12C5A例程(20)-触摸屏驱动-STC12C5A routine (20)- (20) touch screen driver STC12C5A routine- touch screen driver
DB1_001_KEIL4
- DuYang DB1-001 炫彩LED小夜灯-DuYang DB1-001 LED lamp
ads7886-tlv5616
- AD和DA和联调程序。包含ads7886驱动与tvl5616驱动以及串口驱动。功能如下，通过tvl5616送出电压值，然后再用ads7886采集回来，并通过串口返回到PC，可用串口调试软件看到结果，验证正确与否。特别注意7886的硬件电路，否则可能无法正常采数，详见驱动说明-AD and DA and the FBI procedures. Contains ads7886 drive and tvl5616 drive and serial port driver. Function as f
DS18B201602LCD
- DS18B20温度控制1602LCD显示C51-DS18B20 1602LCD
07-USB
- 用MSP430F5438实现的时USB接口开发程序，变异环境是IAR,初学者挺实用的。-When implemented with the MSP430F5438 USB interface development process, variations environment IAR, very useful for beginners.
dac0832_
- 8位数模转换芯片，有八个通道，51单片机驱动-Eight analog-to-digital conversion chip, with eight channel, 51 SCM driver
msp430aADDA
- 这个程序是基于msp430单片机的，关于宽带直流放大器的控制程序ADDA放大倍数并按键控制LCD显示。-This program is based the msp430 microcontroller, broadband DC amplifier control program ADDA magnification buttons control the LCD display.