资源列表
小车
- 基于51单片机的L298n的循迹pwm+正反转调速(Pwm+ reversible speed tracking)
UCA0
- 基于MSP430G2XX3系列平台的低功耗单片机。代码中提供的是单片机中异步串行通信寄存器UARTA0的使用方法及配置。初学者可以参考借鉴，降低入门难度。(Low power MCU based on MSP430G2XX3 Series platform. The code provides the use and configuration of asynchronous serial communication register UARTA0 in single chip microcom
WXG_040_01(27E64)(电流s)
- 检测四个电机工作时动态电流，以判断其工作状态。(The dynamic currents of four motors are detected to determine their working state.)
18B20
- 使用51单片机，18B20温度传感器对外部温度，采集显示(Temperature acquisition and display of 51 single chip microcomputer 18B20)
I2C
- 实现了lpc2103的iic的功能，使用片上iic控制器(The IIC function of LPC2103 is realized, and the on-chip IIC controller is used.)
lanya2
- 在keil中测试HC05主从机蓝牙模块，实现基本通信，完成测试、。(In keil, we test the HC05 master slave Bluetooth module, realize the basic communication, complete the test.)
IIC-24C02基本读写
- 51单片机IIC总线实现24C02基本读写(Basic reading and writing of 24C02 by IIC bus)
8051 RTOSsignal
- This project show you how to use signal in rtx51tiny 8051
15 红外遥控收发仿真
- 用proteus仿真红外接收，发射，已成功。(Proteus simulation of infrared receiving, launching, has been successful.)
0019步进电机位置控制
- 可以根据给定的数值控制步进电机所转的角度(The angle of stepping motor can be controlled according to the given value.)
RC500-sch-PCB
- RC500原理图和天线图, 天线是不好设计的,但是包里面有现成的, 可以直接用(RC500 schematic and the antenna, the antenna is a bad design, but the package inside the off-the-shelf, can be directly used)
直流电机测速
- 使用51单片机，通过按键控制直流电机的转速并测量直流电机的转速，并实时用数码管显示出来。(51 traffic lights, time is 60 seconds, control the intersection of traffic, there are digital tube display, the program is easy to change.)