资源列表
juzhenanjian
- 矩阵按键代码 基于stc89c52 很好用的程序，经过测试，欢迎下载-Matrix key code based on stc89c52 good procedure, tested, welcome to download
contents
- This the source code for the ARM avr 32 controllers and contains a blinking LED source codes-This is the source code for the ARM avr 32 controllers and contains a blinking LED source codes
T6963driver
- T6963控制芯片的LCM显示程序，开发环境: Keil C51 V6.14，测试成功-T6963 c program
SONIX_QN8027
- Sonix 2501B 控制 QN8027 的程序，汇编语言。基本完整。绝对原创，给你一个非常好的汇编语言风格示范。-QN8027 control by Sonix 2501B.
Autoscan
- msp430f5529AD的多通道扫描程序。仅供参考学习-msp430f5529AD multi-channel scanning process. Reference only to learn
C51Milk
- Keil uVision2下用C语言开发的牛奶巴斯德杀菌嵌入式系统代码-Keil uVision2 using C language development milk sterilization Pasteur embedded system code
AVR_Stepper
- 基于atmega16l单片机开发四相八拍步进电机驱动，步进电机带64倍降速，程序在8Mhz晶振下调试通过。-Four-phase development based on atmega16l MCU shot eight stepper motor driver, stepper motor with 64 times the deceleration, the program to debug through the 8Mhz crystal.
AVRC_com_Demo
- 单片机串口通讯源程序，具体功能经过测试，请大家-microcontroller serial communication program, the specific function of the test, please s
avr_usart0
- 这是一个针对AVR单片机的串口编程，里面有原理图，加上串口源码。针对型号为ATMEGA128的AVR单片机使用。其它的芯片，如果寄存器一样也可套用。
MCU
- 基于8051的四路数据采集系统设计（单次阻尼振荡波形，热电偶温度输出，可调直流信号输出，扩展口）Proteus电路图+KeilC语言-The design of Four lines data-collecting system based on 8051MCU
int0
- 正常情况下，p1口所接的发光管依次循环点亮。当s1按下时，产生int0中断，此时8只发光管全亮全暗交替八次。然后回复正常-Under normal circumstances, p1 port of LED then turn the light cycle. When s1 is pressed, the resulting int0 interrupt, then 8 LED light all dark turn all eight. Then back to normal
motor
- 51内核单片机各模块实现（keilc uv4编程环境）源码之 电机驱动-51-core MCU modules the (keilc uv4 programming environment) source of motor-driven