资源列表
max5
- max518的初始化文件，能实现16F877A与max518通信，输出方波
zhangxiangtuowei
- HL1606正向拖尾程序，单片机为合泰单片机。C语言程序-HL1606 forward tailing procedure, SCM is a composite Thailand microcontroller. C language program
sicanp
- this program about satelit constalation-this is program about satelit constalation
uart
- Atmel 的Atmega48V的串口通信代码，可完成ＣＰＵ和上层代码串口通信-Atmel' s Atmega48V the serial communication code, to be completed by the upper code CPU and serial communication
SurveimeterDigital
- survey meter digital using avr8535
pwm
- *此程序为基于C51单片机 周期占空比皆可调的PWM波程序 *通过T0控制周期 *通过T1控制占空比-* This program is based on C51 microcontroller duty cycle of PWM wave Jieke transfer procedures* T0 control by controlling duty cycle* through T1
xiaoguo
- This my dot matrix commonly used extraction tools, very easy to use, is the most perfect one of the many software matrix extract, after extracting a direct run, no installation, the use of special convenience, a variety -This is my dot matrix commonl
001LED-dan-deng-pao-dong
- 特别适合单片机初学者的C语言程序，值得借鉴-Particularly suitable for single-chip C-language program for beginners, it is worth drawing
shumaguanshanshuo
- 数码管闪烁，应用于单片机。采用VC编程。-failed to translate
20120429
- 基于atmega16的用AD转换控制方波频率的程序-Based on the ATmega16with the AD conversion control of square wave frequency program
spark_light
- 实现51单片机的流水灯作业，二极管共阳，使用两个8位I/O口实现控制-51 MCU operating light water, diode common anode, two 8-bit I/O Port Control
timer
- 这个代码中，我们用用计数器0来作为一个信号捕捉的端口。当在P3.4端口采集到下降沿的时候，会在数码管上加1.（P1.0连接到P3.4)在程序代码中，我们给了P1.0端口，进行 一个赋值，让它电平交替变化。每变化一次，数码管的值就会加1。-In this code, we use counter 0 as a signal to capture the port. When the P3.4 port to capture the falling edge of time, will increa