资源列表
Bike_Fuction
- 电动自行车上，通过对助力器发出的脉冲信号的频率的采样，控制器车速，功能程序。-Electric bicycle on the issue of booster pulse signal sampling frequency, the speed controller, function procedures.
EEP_PRO
- sonix，24系列EEP读写子程序，使用接口函数，可直接调用-sonix, 24 series of EEP read and write subroutines, using the interface functions can directly call the
fet140_uart01_0115k
- echo UART for msp430
main
- 单片机程序控制实现函数发生器的功能，在函数发生器中起主控制作用-SCM process control functions to achieve the function generator, function generator in the role play the main control
i2c_sf04
- pic18f读写（I2C)sfm4100Series压差传感器的程序-PIC18F6722 read(I2C) sfm4100Series
IR
- 基于ATMEGA8的一段红外线报警程序，当物体拦隔了红外线的接收端，蜂鸣器将自动报警-ATMEGA8 period based on infrared alarm program, when the object stopped across the infrared receiver, the buzzer will alarm
fet140_uart07_09600
- MSP430串口0通信。波特率9600，回显收到的8个字符。具有参考价值-his program demonstrates a full-duplex 9600-baud UART using USART0 and a 32kHz crystal. The program will wait in LPM3, and receive a string[8] and echo back the complete string.
IIC3
- 基于AVR单片机的IIC通信协议的相关源码 -The IIC based on AVR microcontroller communication protocol related to source
MSP430x261x_FlashWrite
- MSP430x261x_Flash C 语言代码程序，从段Ｃ复制到段Ｄ -MSP430x261x_Flash C language code program, copied from section to section C D
1
- 用外部中断输入引脚RB0/INT接收连接在该引脚上的按键信息。每检测到一次按键就对8位计数器COUNT 加1，将COUNT的值直接送给8个发光二极管显示。 单片机复位后，COUNT的初始值为二进制数00000000B，对应的8只发光二极管都不亮。当按键RB0/INT被按下时，COUNT的值加1，发光二极管D0点亮，以表示二进制数00000001B。然后松开按键之后，如果再次按下RB0/INT时，COUNT的值加1，发光二极管D1点亮，以表示二进制数00000010B……，以此类推。通过观测
achieve-DA-function
- 单片机去控制PCF8591T去实现DA功能。 这个代码也要在示波器上才能观测到，DA输出一个正弦波。-Microcontroller to control PCF8591T to achieve DA function. This code also can be observed on an oscilloscope, DA output a sine wave.
main
- msp430g2553 基于ad多通道设计。。可以同时采样多个通道，进行转换-Msp430g2553 based on multi-channel AD design. Can sample multiple channels at the same time, carries on the transformation