- 01 是ａｔｍｅｇａ128的ｅｅｐｒｏｍ的读取范例
- jingmeitongyongqiyeyuanma 精美通用企业源码 精美通用企业源码 精美通用企业源码
- 00 单片机例程 for 24C 亲测好使的程序
- eeprom #include <intrins.h> #include <reg52.h> //52系列单片机头文件 #include <51hei.H> #define uchar unsigned char #define uint unsigned int #define RdCommand 0x01 //定义ISP的操作命令 #define PrgCommand 0x02 #define EraseCommand 0x03 #define WaitTime 0x01 //定义CPU的等待时间 sfr ISP
- nibianqi 基于mc9s12xs128单片机的三项逆变器控制程序
资源列表
source-code-of-brushless-motor
- 无刷电机驱动器源代码。基于无传感器方案的无刷电机启动器。核心是换向角度检测：即电机反电势波形数据处理，经过衰减滤波，取出过零相位。应为低速反电势波形dB过小，波形扰动太大，本程序还不能稳定处理10Hz以下的换向计算。,Brushless motor driver source code. Program based on the sensorless brushless motor starter. Is the core to the point of view for detection:
STM32---SD
- MiniSTM3开发板就带有SD卡接口，利用STM32自带的SPI接口，最大通信速度可达18Mbps，每秒可传输数据2M字节以上，对于一般应用足够了。本节将向大家介绍，如何在 MiniSTM32开发板上读取SD卡。本-MiniSTM32 SD
2103ad1
- arm2103的ad转换程序，软件控制方式，采样通过定时器控制，非中断方式-the ad conversion arm2103 program, software control, the sampling timer control, non-disruptive way
USB
- 关于学习mega16单片机的学习范例，这是驱动USB的程序。-MCU learning about learning mega16 example of this is USB drive the program.
20_USB
- AVR单片机控制USB的试验程序，可以学习一下，对新学的人来说可以加深对AVR单片机的理解-AVR MCU USB test program, you can learn about new people who can learn to deepen the understanding of the AVR
FontConverter
- 将Windows矢量字体转换为可供嵌入式系统的LCD、LED等直接使用的十六进制数组，在ADS1.2中实测可直接include使用。-This is a font coverter which can convert any font style in windows to pixel array(in hex value) that can be used in embedded system. File gernerated by this tool can be included in p
SW-XEP100-PLL-Setup-CW47
- MC9S12XEP100 PLL时钟配置例程-MC9S12XEP100 PLL setup
51zhongduan
- 51单片机的中断内容汇总归纳，尤其适合于初学者。-51 MCU as the interruption of the consolidation, especially for beginners.
CC2420
- 这是一个项目的节点程序，单片机使用avr,无线通信模块使用CC2420(支持Zigbee协议）,此源码包括发送端和接收端-This is a project node procedure, single-chip using avr, of wireless communication module using the CC2420 (support for Zigbee Protocol), the source, including the sending end and receiving
iccavr
- 利用at90s515单片机产生两路12位精度的正弦波。可通可上位机软件修改波形的幅度，频率，相位。-The use of at90s515 microcontroller to generate two-way 12-bit precision sine wave. Through the PC software to modify the amplitude, frequency and phase of the waveform.
Dc-motor
- 基于ARM2103的直流电机控制，可供参考-Based on the dc motor control ARM2103, available for reference
notouch_ic
- 非接触IC卡，读卡器源码，适用于51单片机-Non-contact IC card reader source code, applied to 51 single-chip