资源列表
430danpianji
- 本文件中的代码展现了430单片机的各模块的用法。包括键盘与LCD的组合用法、键盘与步进电机的组合用法，串口与步进电机的组合用法、A/D转换模块与LCD的组合用法以及键盘与LED的组合用法，且配有对应的开发板PDF电路图，这对初学430单片机的同志很有帮助。-The code in the file to show 430 microcontroller module usage. Including the use of a combination of the keyboard and the
dianzhenLED(1664)
- 意外之喜偶然获得了这个51单片机驱动LED点阵的例子，很佩服这位仁兄，尤其是他的硬件设计——利用总线驱动LED点阵更是值得学习。（有proteus仿真原理图）-Occasional pleasant surprise was the 51 single-chip LED dot-matrix-driven example of this man very much admired, especially his hardware design- the use of bus driver LED
CC2430Radio
- CC2430无线通信，主要采用了DMA通道传输，能够用于无线控制的场合，实现双向通信和监控,采用了IAR开发环境。-CC2430 wireless communication DMA Channel data transmission two-way communication real time monitoring
ch375.c
- ch375 主机 辅机 通讯资料 对于初学单片机通讯很好的 芯片资料-ch375 host auxiliary communication information for the beginner a good chip data communication chip
Sampling-PCB
- 电压、电流及漏电的采样电路，由整流、分压、滤波等功能电路组成。-Voltage, current and the drain of the sampling circuit, the rectified voltage divider, the filter circuit, and other functions.
PIC_LED
- PIC单片机LED模块测试,程序简洁,已经通过测试-PIC microcontroller LED module testing, process simplicity, has been tested
XC800-FOC-KEIL
- 采用ukeil 写的电机FOC控制程序，MCU为XC886-Written using ukeil FOC motor control procedures, MCU for XC886
J240128A
- J240128ALCD显示器的资料和C驱动源码-J240128ALCD display information source and C Drive
xianshi
- MSP430F149与A系列彩屏之间的串口通讯程序- Serial communication between msp430F169 and C Monitor
FLY8000
- TI射频芯片CC1100例程，FLY8000-无线温度发送和接收(51)。-TI RF the chip CC1100 routine, FLY8000-Wireless Temperature sending and receiving (51).
seg7_1
- 用VHTL描述7段数码管器，输入为一个四位二进制，在数码管上显示数字的同时也显示这四位二进制。使用了port map语句
Infrared-Thermometer-
- 基于51单片机的红外线测温仪(范文)，值得借鉴！-51 microcontroller-based infrared thermometer (Pham Van), it is worth learning!