资源列表
1602protues
- 带protues 仿真电路图，1602液晶显示，带注释-Circuit simulation with protues, 1602 LCD, with comments
595shumag
- SPI方式的74HC595驱动数码管 2位数码管的 C程序 -74HC595 SPI mode driver digital 2 digital C program
ANF
- 自适应陷波器的simulink仿真 不信你可以下载看一看-This is a simulation of adaptive notch filter.
已知两点求第三点的双字节无符号定点插值算法
- 两个点的线性插值定点数算法 说明：1、基本公式 y=( y2-y1 ) ( x-x1 ) / ( x2-x1 ) + y1 2、根据直线斜率的正负、内插外插的不同，分为6种情况。 3.参见文件夹中的“插值算法的6种情况”一图。-two points of linear interpolation algorithm for determining points : one, the basic formula y = (y2 - y1) (x-x) / (x2 - x1) y1 2,
51_dht11
- 基于89s51的温湿度传感器，传感器的型号是dht11,可以同时测量温度和湿度。-Based on 89 s51 temperature and humidity sensors, sensor model is dht11, can measure temperature and humidity at the same time.
c51设计编码规范
- C51语言编码设计规范，说的很详细的。-C51 coding design specifications, said the very detailed.
TLC549
- AD转换 TLC549 C语言编程-AD conversion
Serial-receiver
- 本实例中，开发板通过串口与PC上运行的上位机软件通信，使用了modelsim 定时器T0作为波特率发生器，串口波特率为9600。-In this instance, the development board communication through the serial port on a PC running PC software, use the timer T0 as a baud rate generator, serial port baud rate to 9600.
18remember
- 每次开机都将次数加1 并存储到EEPROM。这样就能直观的看到机器的使用次数，用P1口 LED做为显示，次数大于256是将溢出，按复位模拟开机 或者直接通过开关开机-Starting up at every time will increase in the number 1 and stored in the EEPROM. It can visually see the machine usageUsing P1 LED as a display, number greater than 2
guangdianguan
- 进行51单片机主控智能车模块测试时用光电管返回的道路信息控制舵机以一定角度转向。-Intelligent control for 51 single-chip module test vehicle with photocell control to return to the road information to a certain point of gear shift.
GLOBAL_NO_1
- 单片机通过矩阵键盘扫描获取键值，然后通过串口发送发送-SCM through the matrix keyboard scan for key value, and then send sent through a serial port
PWM
- AVR Atiny13 单片机的PWM操作例程，无需外加晶振即可工作，仅供参考。-AVR Atiny13 microcontroller PWM operation routines, no external crystal can work for reference purposes only.