资源列表
多路超声波模块的使用
- 多路超声波检测并通过一块液晶屏进行显示距离的参数，能够实时检测实时显示(Multiplex ultrasonic inspection display)
Stopwatch
- 基于51单片机的秒表设计，需要的可以下载(Stopwatch design based on 51 single-chip, you can download)
投影机3
- 单片机和投影机串口通讯，实现对投影仪的开关控制(MCU and projector serial communication, to achieve the projector switch control)
GPIO_IOToggle
- 对gpio的控制，拉高拉低的功能实现，芯片选型为stm32f413.(The control of the GPIO, the realization of the function of the low Lagaola.)
新建文件夹
- 对于八路抢答器的具体程序的 个人见解 仅仅是个人对八路抢答器 的程序了解 望采纳(visual For the eight line responder specific procedures of personal opinion is only personal understanding of the eight responder program, hope to adopt)
SW_Stepper_motor_motion_control_driver
- Freescale单片机步进电机驱动器的外设接口驱动程序(Contains the Stepper motor driver external APIs)
Silicon Labs 步进电机参考设计源码
- Silicon Labs 步进电机参考设计源码(Silicon Labs Stepper motor reference design source code)
1602渐入显示
- 用51单片机编程，实现1602渐入显示，两行文字(With 51 microcontroller programming, 1602 gradually into the display, two lines of text)
程序
- 基于L298N的六路循迹小车程序，个人用过，比较实用(Six road car tracking program based on L298N)
I2Cmaster
- 颜色传感器的arduino 程序 I2Cde(The Arduino program I2Cde of the color sensor)
STC
- stc头文件，添加头文件！扩充STC头文件库！(STC header file, add header file! Expand the STC header file library!)
light3
- 流水灯设计模式3，所用软件为keil uvision4编写，并用multisim进行仿真设计，可实现流水灯造作3。(Water lamp design mode 3, the software used for keil uvision4 writing, and the use of Multisim Simulation design, can realize the flow of water lamp 3.)