资源列表
SD2
- 430和LCD显示器的接口驱动程序,调试已经通过了,没有错误.-430 interface and LCD display drivers, debugging has been passed, no errors.
12864_LCD
- 这是我写的一个LCD程序，主要控制端口有：ST0、SET、E、RW、RS、CSB、CSA，不要搞错了哈-This is a program I wrote an LCD, the main control port are: ST0, SET, E, RW, RS, CSB, CSA, make no mistake Kazakhstan ~ ~呵呵~ ~
PS2-keyboard
- PS2的键盘，在51可以用，移植性很强，可以在很多地方用到的，好东西大家一起分享啊-PS2 keyboard, the 51 can use, highly portable, can be used in many places, good things to share with everyone ah
Feed-the-dog
- 通过按键喂狗防止溢出复位 看门狗演示程序 在16383个机器周期内必须至少喂狗一次 标准AT89s52单片机试验通过-Feed the dog through the button to reset the watchdog demo program to prevent overflow in the 16383 machine cycle must feed the dog at least once a standard microcontroller test by AT8
hilonB
- hilon B协议编程，已在电力上CAN总线系统上应用，开发环境16位单片机-hilon B programming agreement has been in power on the CAN bus system application development environment for 16-bit MCUs
Protel-LD3320
- LD3320的protel99se的，工程文件。内有LD3320的PCB封装和原理图元件库文件。-LD3320 protel99se, engineering documents.There were LD3320 principle diagram of the PCB assembly and component library file.
DC_motor_PWM_C51_timer
- 利用51单片机的定时器，在普通IO口输出PWM波形-The use of 51 MCU timer, the common IO port output PWM waveform
SCON
- 单片机开发汇编基础，学会使用SCON从这里开始-Compilation of basic single-chip development and learn to use the SCON from here
PICSerialSlave
- connecting A PIC id as slave in serial communication
44anjian
- 四四矩阵按键的算法程序，汇编语言编写，做为一个调整参数的系统式必不可少的-44 key matrix algorithm program written in assembly language, adjust the parameters of the system as a style essential
XIYIJI
- 三菱所用的PLC编写的洗衣机程序 电工方面-failed to translate
shuangjitongxun
- RS485双机通讯实验-主机，程序运行后,主机将间隔的发送0-255至从机，从机接收到后在从机的1602液晶上进行显示-Dual RS485 communication experiment- the host, the program runs, the host will send interval 0-255 to the slave, after receiving the slave to slave in 1602 on the liquid crystal display