资源列表
119P01
- 通过电位器调节时间循环的时间，控制开关管的导通和关闭(Adjust the time of the cycle by potentiometer)
13.5v基准电压pretues仿真
- proteus仿真13.5V基准电压输出，用于对讲机等需要基准电压的地方(proteus Multisim 13.5V output)
ug474
- Based on multi-document image obtained combining technique, Thermonuclear using weighting factors ML estimation method can be a good signal to noise ratio.
STC12xx
- stc12xx系列单片机比传统51多出功能的操作库函数(The function of STC12xx MCU)
1-流水灯
- 流水灯,硬件需求 LY-51S开发板 + USBASP下载器 + M8转换板（含芯片)(Water lights ,need LY-51S Development board ,USBASP downloader and M8 onversion board including chip.)
FolderSpy
- ezdhgjh gffghfgh dgtertuyuiyui retertertert
STC触摸开关C
- 基于STC触摸开关C的相关开发程序，ADC对电容式电压采集(Based on STC touch switch C related development procedures, ADC capacitor voltage acquisition sequence)
温度传感器
- 利用51单片机和温度传感器，实现温度测量并完成AD转换(Using 51 single-chip microcomputer and temperature sensor to achieve temperature measurement and complete the AD conversion)
显示
- 使用1602显示AD采集的数据。其中带有AD转换的采集程序，用lcd1602显示字符串和数字(Use 1602 to display data collected by AD)
timer
- ARM m4 FPGA开发模块，用于timer模块的开发(ARM M4 FPGA development module, used for the development of timer module)
OV7670+FIFO+3.0TFT
- ov7670 + FIFO原理，入门，简述，应用(Ov7670 + FIFO principle, introduction, brief descr iption, application)
User（IIC SUART3）
- 用stm8硬件 I2C 中断方式 发送/接收数据， 经过查阅手册和反复验证，已经完成了，话不多说，上代码。(With stm8 hardware I2C interrupt mode to send / receive data, After reviewing the manual and repeated verification, has been completed, then not much on the code.)