资源列表
UART0_usb
- c8051f020 实现ADC0采样芯片温度，通过LCD显示，并通过串口0再经过CP2102芯片“UART-USE”（J19）发送到PC机, 请使用串口调试工具调试-c8051f020 to achieve ADC0 sampling chip temperature, through the LCD display, and through the serial port 0 go through CP2102 chip, " UART-USE" (J19) sent
fre
- 基于2051的频率计设计，有3个档位，可自动换挡，并有led作为档位显示-frequency measure based on2051
110
- 使用NXP(飞利浦)公司的LCP915单片机产生任意波形的程序，使用了DA-Use of NXP (Philips) microcontroller company LCP915 arbitrary waveform generation, the use of the DA
1602
- 此程序基于STC89C52单片机，详细介绍了利用液晶显示屏1602A进行显示的单片机程序-This procedure is based on the STC89C52 SCM details the MCU program for display use LCD 1602A
ch432
- avr单片机，STDIO6.0开发环境，ch432接口程序，SPI接口转2串口芯片。-avr microcontroller, STDIO6.0 development environment, ch432 interface program, SPI Interface to two serial chip.
123
- Micro2440 开发板 的Jlink 的初始化文件-Micro2440 initial file on the Plantform of Jlink
delay-control-LED-blink
- 使用AT89S52单片机核心芯片，通过c语言编程，使用delay函数控制led闪烁-Using AT89S52 microcontroller core chip, through the c programming language, using the delay function control led flashing
KEYSCAN
- 键盘扫描，自己编的，可以在89C51上运行的汇编程序-keyscan 89c51 asm
LCD1602
- 该程序用于实现89C52驱动LCD1602显示-The procedures used to implement the 89C52 driver LCD1602 display
MENU
- 单片机在12864上实现的菜单显示，可扩展-12864 chip in the menu on the display to achieve scalable
MAKE_1mS
- The MODE pin establishes whether communication with the 3D MagIC will comply with Standard Mode protocol (see Section 5) or Legacy Mode protocol (see Section 6). The MODE pin should be grounded (connected to DVSS) to operate in Standard Mode, a
jixiefeisuoanjianchengxu
- 用机械飞梭做旋转选择和确定，加入向左或向右旋转判断，按键去抖。可供参考。-Shuttle done by mechanical rotary selection and determination to join the left or right judgment, debounces. For reference.