资源列表
WG34L
- 通过５１单片机的Ｉ／Ｏ口模拟ＷＧ３４信号，并读取以ＷＧ３４协议通讯的ＩＤ卡
atmel161_IDT821054
- ATmega161控制IDT821054进行4路PCM编解码的C语言源码。-ATmega161 control IDT821054 PCM codec for 4 C-language source.
UART
- 程序是针对MSP430f14系列和MSP430f16系列的，这两款单片机都可以进行同步或是异步通信，甚至169的模块USART0还能进行进行I2C协议通信。改程序为异步串行通信。-Program is for MSP430f14 series and MSP430f16 series, both the microcontroller can be synchronized or asynchronous communication, and even modules USART0 169
liushuideng-
- 单片机流水灯程序，STC89C52 单片机流水灯程序，STC89C52 -SCM process water lights, STC89C52
1
- 有关于使用ISD1700芯片在单片机环境下的语音系统，-ISD1700 chip on the use of environment in the single-chip audio system,
C_Programming_run_time_information_update_status_b
- C编程在运行时更新状态栏信息C Programming in the run-time information update status bar-C Programming in the run-time information update status bar
C
- 用c语言写的CH450DS芯片的程序，里面的协议是模拟I2C-Using c language to write the CH450DS chip program, the inside of the protocol is simulated I2C
I2C_next_two_directions
- 本文介绍的I2C未来的两个扩展方向：热插拔和远距离通迅，其中包括电路设计。-This article describes the extension of the I2C next two directions: hot swap and long-distance Communications, which includes circuit design.
My_project_AM2301
- 在PIC18系列芯片上读写温湿度传感器模块AM2301，并把数据存储在EEPRom，当与电脑串口通讯时，会把数据导出来-PIC18 family on the chip to read and write the temperature and humidity sensor module AM2301, data storage EEPRom, when communication with the computer serial port, will the data lead out
D8-card-reader-test-for-pb6.0
- 德卡D8读卡器C#测试程序，用于测试与D8读卡器的通信，实现了读卡器的初始化，蜂鸣，密码校验和读写卡操作。-A test program for D&C s D8 card reader, it is used to test the communication with the D8 reader, and it has achieved the operation of the Initialization, beep, password checking reading and writi
Four-LED-lights
- 点亮四个LED的程序，学习单片机的可以参考一个-Four leds light up program, learning can refer to a single chip microcomputer
wdcl
- 用于温度测量，将测量到的数据用液晶显示出来，单片机atmega16制作的源程序-For temperature measurements, the data will be measured by using liquid crystal display, microcontroller source code produced by atmega16