资源列表
paomadeng
- 跑灯类程序，对于刚刚接触单片机的朋友有很大的帮助-Running lights type of proceeding, for a friend just contact microcontroller very helpful
xunjibizhang
- 这是本人通过实验认为可行的基于51单片机智能循迹、避障程序源代码，供大家参考。-This is I think through the experiment feasible based on 51 single-chip smart tracking, obstacle avoidance program source code, for your reference
lesson02code-2
- 2个按键分别控制1一个灯闪亮的单片机简单程序，通过测试的。-Two buttons control the flashing lights of a single chip a simple procedure, passed the tests.
jiuhuchechesheng
- 通过软件延时，使P3.4引脚输出两种信号，1kHz和2kHz频率，并且每隔一秒变化一次，交替进行。开关K做发声控制。-Software delay to P3.4 pin output two signals, 1kHz and 2kHz frequency, and changes every second time, alternately. Voice control switch K to do.
Led_Light
- 周立功单片机中使多个led等分别亮暗闪烁交替的程序包-Zhou, who single-chip manipulation led, respectively, the bright and dark flashes alternately package
part4.4
- 芯片程序，了解stc芯片有助于单片机开发-chip study
222
- 步进电机系统系统硬件结构框图,步进电机系统系统硬件结构框图
c
- cc2210无线传输，串口收发数据，在Keil C中实现，基于802.15.4-wireless cc2210
changguipid
- 常规PID解耦控制器实现的国产某300MW直流燃煤机组解耦控制-Conventional PID controller to achieve decoupling of the DC made a 300MW coal-fired units Decoupling Control
mactx
- * A default is provided if a value is not specified. If the default * is not appropriate, a #define should be added within hal_mac_cfg.h.- * A default is provided if a value is not specified. If the default * is not appropriate, a#de
VBshangweiji
- 采用VB编写的上位机程序,仅供参考-VB PC prepared by the procedure
dianji
- 用汇编写的51的步进电机控制程序，在keil下测试通过-Written in assembly 51 of the stepping motor control program, under the test adopted in keil