资源列表
RC_A7139_x3_433MHz-Band-V0.0
- 51单片机驱动的A7139的433模块，可进行短距离的通信-51 MCU-driven A7139 433 modules can communicate over short distances
PID_Turning
- 先进PID控制matlab仿真（第二版） 1、所有仿真算法按章归类，光盘中的程序名与书中一一对应。 2、将光盘中的仿真程序复制到硬盘MATLAB运行的路径中，便可仿真 -Advanced PID control matlab simulation (second edition) 1, all the simulation algorithm classified by chapter, the program name CD-ROM with the book-one correspond
mcp3421
- MCP3421驱动代码以及配程序代码（见头文件).-The MCP3421 driver code as well as allocation process
51LED
- LY51(AVR)-L3E开发板的 AT98C52 单片机控制发光二极管-
tinysh
- ucos 下的命令行扩展。方便各种接口的设置与外界交互。-The UCOS under command line extended. The convenient interface settings to interact with the outside world.
delay
- 89c51这是一个5ms的延时的 已经实践过了 没有问题-89c51 This is a 5ms delay already practiced with no problem
bit-clock
- m sure you ve seen analog clocks, digital clocks and maybe even binary clocks! Traditionally, analog clocks (or watches) display time by a continuous motion of two (hour, minute) or three (second) rotating pointers pointing to numbers arrayed on a c
rfid_U2270
- avr单片机用2207读写感应卡的代码，有一定的参考作用-avr microcontroller proximity card reader with the 2207 code, there is some reference
51baudrate
- 8051单片机的串口波特率发生器计算器,对做51但片机开发的同学们应该有很大帮助-8051 serial port baud rate generator calculator, to do 51 but the machine developed by students should be of great help
ucos_GUI_Typein
- ucos上的键盘程序编写，使用到ucos上的控件来实现全拼键盘的代码，非常适合开发者借鉴。-The keyboard of the UCOS program, used to UCOS controls to achieve full keyboard code, very suitable for developers to reference.
MSP430
- MSP430头文件详解，介绍特殊功能寄存器地址和控制位，看门狗定时器的寄存器定义， 硬件乘法器的寄存器定义。-Detailed MSP430 header files, describes the special function registers the address and control bits, the watchdog timer register definitions, hardware multiplier register definitions.
t4CAP
- 基于C8051F040单片机，关于定时、计数器T4的使用示例程序-C8051F040 microcontroller based on timing counter sample program using T4