资源列表
KinibiOTP.tar
- smartphone kinibi OTP OTP
lux-apds22
- sensosr data from light via user
iap心得
- 单片机引导程序资料，对新程序的引导写入以及写入失败旧程序恢复(Single chip boot program data, the new program boot write and write failed, the old program recovery)
Matlab_Butter
- 用C语言实现matlab的butter函数中低通和带通功能,高通和带阻没写,有兴趣的可以自己加入.(Using C language to achieve matlab butter function low-pass and band-pass function, high pass and band stop did not write)
arduino code
- arduino+bh1750模块对于测环境照度的代码实现(Code implementation of arduino+bh1750 module for measuring environmental illuminance)
Timer
- Timer code for Avr microcontroller
PIC单片机的I2C 24LC02 C读写程序
- 1, 24LC02器件地址是1010000R/W. 2, 数组写入24LC02采取页写方式. 3, 数组code从24LC02读出时采取自由读方式. 4, 采用4.00M晶体。 5，采用软件I2C。(1, the 24LC02 device address is 1010000R/W. 2, take 24LC02 array to write page write mode. 3, the array code take free read read from the 24
c328r-master
- somearduino code for nsatl en arduno id
STM32F334_LLC_SR
- stm32用于软开关谐振电源LLC的设计，130K谐振频率(Stm32 is used to control resonance LLC soft switching power supply , 130k frequency)
GP22_main_AN034
- 官方GP22的使用例程，使用stm32的硬件SPI接口通讯控制，而不是采用网上常见的模拟SPI的通讯方式。模拟SPI通讯方式极大的限制了GP22处理的速度。(The official GP22 routine uses the STM32 hardware SPI interface communication control, rather than the use of common online analog SPI communication mode. Analog SPI commu
信号仪
- 本程序采用MSP430F149低功耗芯片，由键盘按键输入所需控制的电流源的值输出，电流源范围4~20mA，通过功能转换算法，输出可在百分比、数值之间任意切换，具备阶梯控制输出，输出可在五点任意设定，单按键电源控制更适合电池供电使用。(This program uses low power MSP430F149 chip, the current source control required by the keyboard input value of the output current ra
PWM
- 这是一个pwm的simulink模型后缀是mdl可直接打开使用(This is a PWM Simulink model suffix that MDL can open directly to use)