资源列表
72131
- PLL frequency synthesizer 72131驱动(PLL frequency synthesizer 72131 driver)
main
- 串口通讯主机程序，主机发送字节，等待从机响应，附带crc 校验(USART communication routines of master board)
基于51单片机超声波蔽障
- 基于51单片机的超声波避障，有小车的转弯，直走等程序(Ultrasonic obstacle avoidance based on 51 single chip microcomputer)
Desktop
- tm1629a 驱动，LED驱动IC 芯片， 模拟驱动(Tm1629a driver, LED driver IC chip, analog driver)
ht1261
- ht1261芯片的驱动，可以用此芯片驱动LCD屏(The ht1261 drive, it will be used to drive the LCD)
NRF24L01
- 基于stm32f103c8t6的spi2搭建的nrf24l01通迅(Basing spi2 of stm32f103c8t6 to communicate with nrf24l01)
GPS Library for Proteus
- GPS Library for Proteus
stm8-AIN0 采集
- 利用 AIN0 采集旋钮的电压值，TIM2_CH1 捕获红外信号 ，TIM1_CH1 输出PWM 控制灯光 。(The voltage value of the knob is collected by AIN0, the TIM2_CH1 is captured by the infrared signal and the TIM1_CH1 output PWM controls the light.)
报警器
- 温度持续报警器，连续温度采集检测添加报警信息(Continuous temperature alarm, continuous temperature collection and detection, add alarm information.)
程序设计
- 如果要将此应用项目移植到开发板上，只需要根据此项目的电路图修改管脚，改成我们开发板按键和LCD及蜂鸣器对应的管脚上，AD芯片使用的都是一样的，所以只需要将检测AD通道换成AIN3通道，也就是修改程序内通道的口即可。具体怎么修改通道口，参考基础实验例程内AD实验视频。(If you want to transplant this application to the development board, just modify the pin according to the circuit di
driver
- 适合于瑞萨RL芯片的SPI通信底层驱动，使用语言C。(SPI communication underlying driver suitable for Reza RL chip.)
CC1101
- TI 的CC1101的射频芯片 ,然后使用SPI做的驱动,只有.C,主要是CC1101的寄存器配置(TI's CC1101 RF chip, and then use SPI to do the drive, only.C, mainly CC1101's register configuration.)