资源列表
学习单片机的八大步骤
- 学习使用单片机就是理解单片机硬件结构，在汇编或C语言中学会各种功能的初始化设置，以及实现各种功能的程序编制。
ad7656读写源代码
- AD7656读写源代码，我觉得很好的资料-AD7656 source code to read and write, I feel very good information
CANbus
- 基于CAN总线的远距离水位监控系统,独立的CAN 控制器SJA1000基本硬件头文件定义BasicCAN 工作方式.-CAN-based remote water level monitoring system, independent of the basic CAN controller SJA1000 hardware header file defines BasicCAN work.
PID-Temperature-Control
- 白炽灯无极调光.属于PID温控项目子程序,微控制器:PIC16F876A,晶振频率:3.6864M-Promise incandescent dimmer. Belong to PID temperature control project subroutine, microcontrollers: PIC16F876A, crystal frequency: 3.6864M
gobd2
- 51程序,可以用于读取支持OBDii协议的汽车的读取故障码-51 procedures, which can be used to read the agreement to support OBDii car read Fault Code
danpianji-zhongli
- 用光电耦合器测量出重物下降过程中经过任何等距离且在同一垂直线上的三点时间间隔t1,t2,及距离h，然后利用公式g=2h(t1-t2)/t1t2(t1+t2)使用浮点数运算方法计算出g的值。最后由单片机p3口送串行显示。
C8051F236
- 单片机8051串口传输语音原代码,没有测试过,有兴趣的朋友可以try一下.-Single-chip voice the original 8051 serial code, not tested, are interested in friends you can try.
umul0808.src
- 三星单片机SAM88RCRI指令集实现两个无符号的8位二进制数相乘的宏-Samsung SAM88RCRI single-chip instruction set to achieve the two 8-bit unsigned binary number multiplied by the macro
detail1172044[1]
- 网页同时，U13输出为0，封锁 CP信号，使定时电路保持0状态不变，从而实现功能（3）的要求。集成单稳触发器74LS121用于控制报警电路及发声的时间。 -Web page at the same time, U13 output is 0, block CP signal, the timing circuit to maintain the status quo 0, in order to achieve functional (3) requirements. Monostable fl
joystick
- CANopen joystick implementation
Phone-communication-with-the-MCU
- 实现52单片机与手机进行通信，相互传收数据-Achieve 52 microcontroller communicates with the phone, send and receive data to each other
NRF24L01
- nrf24l01接收程序,已经调试成功，可以直接连接使用-nrf24l01 receiving procedures, debugging has been successful, can be connected directly to use