资源列表
pyqxj
- 电喷汽车喷油嘴清洗器用来对喷油嘴的污垢有清洗作用，此为其控制核心的原代码，系统由单片机驱动电机，原码使用C语言，keilc编译器。
8803LCM_DEMO
- 51单片机与控制器为ra8803的液晶屏的显示程序
PS2KB_UART
- mega16读取PS2键盘编码，并且解码以后通过UART发送到串口显示。直接发送不存在按键缓冲的问题D7口接蜂鸣器用于标记有按键按下 -mega16 read PS2 keyboard encoding and decoding through the UART later sent to the serial display. Direct Send button does not exist the problem of buffer D7 I then have to tag buz
qiangdaqi
- 抢答器，可以实现很大的功能，比如，计时、抢答，锁定-qiangdaqi
DAC0832
- 利用DAC0832输出正弦波，方波和锯齿波等-0832 output sine wave, square wave, sawtooth wave
PT2262-decode2
- 用单片机代替PT2272解码PT2262的程序 晶振: 12MHz-PT2262 PT2272 decoding procedures microcontroller instead of crystal: 12MHz
simple-temperatuer
- 简易测温系统：可以通过计算机窗口设定温度上限值，下限值和报警值，通过按键，开始，测温和结束-Simple temperature measurement system: temperature upper limit and lower limit alarm value set by the computer window button start, temperature and end
sle4442 I2C 逻辑加密卡
- sle4442的读写程序-sle4442 literacy procedures
K9F1208
- K9F1208驱动源代码，试验过，可以使用-K9F1208 driver source code
sd
- 1.本程序主要为了实现以下功能： 1）通过对SPI方式对SD卡进行读与写 2）简单的FAT操作 3）对写入的数据进行打印 2.编写日期：09.10.13 3.版本号：V1.0 4.作者：andyluo-uchar SD_read_sector(unsigned long addr,uchar*Buffer)
dt11
- DTH11湿度、温度传感器驱动程序,基于atmel mega8 7.3728M时钟 -DTH11 humidity, temperature sensor drivers, clock based on atmel mega8 7.3728M
EEPROM
- STM32F103ZET6的I2C程序，外设读写AT24C01A器件。程序中有字节读写，随机读写和块读写功能。-STM32F103ZET6 the I2C procedures, read and write AT24C01A peripheral devices. Procedures are byte read and write, random read and write and block read and write capabilities.