资源列表
NE1
- 检测传感器来的高频脉冲信号，单片机看门狗为X5045，还可检测电路电平是否稳定-sensors to detect the high frequency pulse signal MCU watchdog for the X5045, can detect circuit-level stability
jsnk
- 节能时控器，根据每日供电波峰，波谷，定时用电。节能，降低用电成本。C51-AT89C2051 程序
IDEMCUDriver
- 单片机驱动硬盘接口IDE的源代码，用keil c编写-Single-chip IDE interface hard disk drive of the source code, using keil c prepared
VFD
- VFD模块的驱动函数， 驱动芯片为 UPD163-VFD module drive function, and driver chips for the UPD16311
lvx
- 基于单片机的C语言录音功能的实现——课程设计-Implementation of C-recording function- Course Design
xingqi
- 本文件是一个单片机上使用的时钟c代码，其中除了正常准确显示时间外，还有4个按键的设置功能，分别为设置、左移、加1、确定。-This document is for use on a single chip clock c code, which in addition to accurately display the normal time, there are four key setting function, were set up, left, plus 1, OK.
pwm
- pwm波的调制程序，希望能对需要的人有所帮助-pwm wave modulation program, hoping to help people in need
MSP430F247-K9F8G08U0B-Flash
- MSP430F247和K9F8G08U0B Flash 通信 串口调试-Communicate between MSP430F247 and K9F8G08U0B Flash and Use the UASR debug
EDMA
- 基于mpc5606B edma初始化，通过串口发送数据块-Based mpc5606B edma initialized via serial port to send data blocks
Application
- AT45DB081D读写程序，让大家学习下-AT45DB081D write&read
spi
- SPI接口读写flash。spi从串口获取数据，然后发送到flash，再从flash中读出数据发送到串口。-SPI interface to read and write flash. spi obtain data from the serial port, and then sent to the flash, and then sent to the serial read data from the flash.
STCEEPROM
- STC89C51 STCEEPROM 内部记忆存储-STC89C51 STCEEPROM