资源列表
lcd
- MSP430F133f149 液晶显示程序-LCD MSP430F133f149 procedures
W77E58
- 本例程是华邦公司W77E58双串口单片机的串口通讯代码，结合华邦的手册可以方便的移植至应用系统中。-This routine is a Winbond company W77E58 dual serial COM port communication code, combined with Winbond s manual can be easily transplanted to the application system.
dpjC
- 单片机P1.0脚输出频率范围1Hz-1000 Hz的正弦波、方波、三角波、梯形波、锯齿波，并用示波器观察。要求频率可调-MCU P1.0 pin output frequency range of 1Hz-1000 Hz sine wave, square wave, triangle wave, trapezoidal wave, sawtooth, and with the oscilloscope. Required frequency adjustable
SDDriver
- 一个SD卡的驱动程序 直接用单片机调用就可以了-A SD card driver can directly call the MCU
biyeshej
- 基于51单片机的开关量检测并通过LCD显示的C语言程序-51 single-chip switch-based detection and LCD display through a C language program
bmp085
- 温度压力传感器，bmp085 完整简洁程序，采用c语言编写的头文件-Temperature and pressure sensors, bmp085 complete simple procedures, using c language header file
1302
- 1302时钟芯片模块程序，可直接调用里面的子函数，得到相应的功能-failed to translate
AT89s52
- AT89s52单片机 示例程序 初期学习可以作为参考-PLC AT89S52
pt100
- PT100 基于51单片机的热电阻测温，硬件上验证了可用,很难得,一定会对你有帮助。-PT100 resistance temperature measurement based on 51 single-chip, hardware verification is available, hard to come by, and will certainly help you.
TEST
- 51单片机DHT11温湿度测试程序。P0作为LCD的数据控制口，P1.3 作为DHT11data总线 ，P2.1作为状态显示-The 51 microcontroller DHT11 temperature and humidity test procedures. P0 as LCD data control port as DHT11data bus, P2.1, P1.3 as a status display
6
- 左单片机读取双口RAM中分配给右单片机的配置信息存储空间，右单片机读取双口RAM中分配给左单片机的配置信息存储空间，良但片即读取配置信息后可以按照配置信息对自身工作方式等进行设定，达到双机通信的目的，间接实现了一单片机对另一单片机的配置控制。-Left microcontroller reads the dual-port RAM allocated to the right microcontroller configuration information storage space, rig
18b20
- 单片机驱动18b20程序代码，已通过测试，直接用-SCM 18b20 driver code, has been tested directly