资源列表
drive_motor
- AT89C2051驱动步进电动机的小程序-AT89C2051 stepper motor driven small procedures
PID
- the program is for contral system , using the PID.
IO_UART---Fujitsu
- 使用單晶片的一般IO腳來模擬 硬體 UART 通訊介面,好處為可節省hardware uart 的應用!-Fujitsu Use GPIO to simulate uart communication!
vb232
- VB上位机与单片机之间的传输，上位机程序，以0-255传送，上位机可以接受单片的返还值-VB between PC and SCM transmission, host computer procedures to 0-255 transmission, host computer can accept the return of the value of single
extint
- 外部中断实验并显示中断次数-External interrupt interrupted the experiment and shows the number of
IR-remonco_USART
- 利用Atmel128单片机，接收红外遥控信号并利用串口输出的C语言程序。-Atmel128 IR-receiver
diplay
- pic单片的ps/2键盘驱动程序，键盘扫描完的程序通过lcd1602显示-single pic of the ps/2 keyboard driver
acquisition
- 电子式互感器离线校验系统的采集器程序，利用msp430开发的-Electronic Transformer collector system off-line calibration procedures developed by msp430
1602lcd
- 1602lcd软件设计 1602驱动程序-1602lcd software design 1602 driver
main
- 对开发的430F149单片机RS485通信的调试C程序代码 供参考-On the development of the 430F149 MCU RS485 communication debug C code for reference
RS232_send_receive
- 串口RS232的接收与发送程序，接收与发送是分开的，内有程序说明-RS232 serial port to receive and send program, reception and transmission are separated within the descr iption of the procedures
Greenhouse-temperature-control
- 控制大棚的温度保持在一个恒温状态,连接一个电机,当低于一个设置温度的时候自动开启,反之则关闭,有点类似空调的恒温控制-Control greenhouse temperature was maintained in a heated state, connecting an electric motor, and automatically open when below a set temperature, and otherwise is closed, somewhat similar t