资源列表
arduino led
- 用arduino uno控制 7段式led 的程序
piano
- 用单片机实现一个8按键的小电子琴，适合于初级单片机开发者学习用。-the program of a simple eletornic piano which have 8 buttons.
SHIZHONG
- 基于STC89C1的时钟显示程序，带有时间校准和闹钟功能，同时可以进入省电模式，6个数码管分别显示小时，分钟，和秒钟-Based STC89C1 clock display program, with a time calibration and alarm clock function, and can enter the power saving mode, six digital tubes were displayed hours, minutes, and seconds
Remote-control-receiver
- 遥控接收6221编码方式的遥控信号，并解码显示到LCD1602显示屏上,晶体的频率为11.2M。-The remote control receiver 6221 remote control signal of the encoding, decoding and display to the LCD1602 display the frequency of the crystal 11.2M.
ds1302
- ds1302时钟显示电路的驱动程序，用于各种场所可设置的点钟电路-ds1302 clock display circuit driver o' clock in the circuit used for a variety of places can be set
18b20
- 基于c8051f500的单总线DS18B20温度检测系统，-DS18B20 temperature detection system on a single bus
ds12c887
- mcs51单片机、ds12c877、lcd1602制作的电子时钟。-the mcs51 microcontroller, ds12c877, lcd1602 produced electronic clock.
HD7279
- C51语言的HD7279驱动程序-the HD7279 C51 Driver
3
- 电子钟程序，显示部分使用的是74HC595串转并芯片，键盘部分则使用了74HC165并转串芯片。
uart
- 51单片的串口实现数据的收发过程，也可使用中断形式实现数据的收发。-51 single serial port to send and receive process data can also be used to send and receive data interrupt form.
24c02
- 通过24C02中读取数据，然后加1，其中数码管的次数就是开机的次数-Read data through the 24C02, and then add 1, where the number of digital control is the number of boot
wzm
- 用单片机C51语言进行直流电机的控制，分享一下-DC motor control, share microcontroller C51 language