资源列表
KEYC
- 在keil c51 环境下利用中断方式查询 键盘并实现键值查询等功能
93C46
- read and write eeprom,at24c512.debug finished pass.
lift
- 功能完善的四层电梯程序。开门停8秒，上升或者下降一层用时5秒，有五秒倒计时数码管，楼层显示数码管，以及电梯内外楼层请求显示灯。-A well-functioning procedures for four-storey elevator. 8 seconds to open the door stopped, increased or decreased when a layer of 5 seconds, the 5 seconds countdown digital tube, digita
spi_flash
- 8051访问spi flash的读写代码-code for read/write to spi flash
Digital_Codelock
- 电子密码锁，利用单片机控制，密码设置为8为，当输入密码对时绿灯亮，输入错或输入位数不足8位是红灯亮-Electronic code lock, use MCU control, the password is set to 8 to, enter the password to the time when the green light, enter the wrong or less than the median 8-bit input is red light
AT24C010204081632EEPROMdriver
- 24Cxx I2C EEPROM字节读写驱动程序，芯片A0-A1-A2要接GND(24C65接VCC,具体看DataSheet)。-AT24C010204081632 EEPROM driver
DA-AD
- 基于51单片机的AD/DA的程序 由电位器提供模拟输入 -Based on 51 single-chip AD/DA program by potentiometer analog input
Drive_Parallel.h
- 12864驱动程序，基于PIC16F8-12864 drivers, based on PIC16F877
arduino-RFID-IR
- 运行于arduino上的程序，可同时识别RFID标签，和红的发射信号。需要硬件：RFID模块，IR红外接收头。 具体接线方式，文件内已给出。-Arduino running the program on, which can identify RFID tags, and red emission signals. Requires hardware: RFID module, IR infrared receiver. Specific wiring, has been given in th
DHT11
- 温湿传感器DHT11驱动，芯片为STM32系列-DHT11, STM32XX
LED-lattice
- 这是一款51单片机的LED点阵显示的代码，初学者可以通过这套代码了解LED点阵的实现过程。-This is the code of a 51 single LED dot matrix display, beginners can learn to achieve through this process LED dot matrix code.
k60_BootLoader
- k60_BootLoader程序-k60 BootLoader