资源列表
msp430interdemo
- msp430系列单片机,中断demo程序-Controller series microcontroller, interrupted proceedings demo
TIME_4.C
- 数字钟源程序3 数字钟源程序3
time
- 本程序为C8051F32单片机编程，实现的功能为： 6位LED数码管显示时、分和秒的计时 每增加一秒用短音提示 每增加一分用中长音提示 每到整点用长音提示 2个LED灯交替闪烁，闪烁频率为1Hz 看门狗定时器打开
final-at24c512
- DOS下读写AT24C512源码,自己开发-AT24C512 DOS source code to read and write, their development
C51
- 单片机P1口与4个按键连接，用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(-WR)与DA0832、2个741(运放)连接构成波形信号输出电路。 编程使波形信号输出电路输出正弦波信号，并且可通过操作键调节信号的幅度和频率。幅度和频率调节级别从0~10，共11个等级。
main
- Main.Cpp: C++ ostream + stl + exception demonstration .This file is part of the uVision/ARM development tools. Copyright (c) 2005-2007 Keil Software. All rights reserved.This software may only be used under the terms of a valid, current,end user
cunchu
- 实现将2402与89C52单片机的通信，并将结果用12864检验-To achieve the 2402 and 89C52 microcontroller communication, and the results tested with 12864
CAN-ceshirx
- DsPIC30F4011的CAN总线开发程序，该程序是用于CAN数据的定时发送，标准帧8字节-DsPIC30F4011 CAN bus development program, the program is used for CAN data sending, standard frame is 8 bytes
EM78P153S--2012.3.23-by-li-chunxu
- 完整义隆头文件 EM78P153S 2012.3.23 by李春旭.h -The complete ELAN header files EM78P153S 2012.3.23 by Li Chunxu. H
8279
- 利用单片机以及8279实现键盘值的读入并且显示相应的数值，并且实现shift键的联合使用-Reads and displays the corresponding value of the use of single-chip, and the 8279 value of the keyboard, and the joint use of the shift key
uart1
- 基于AVR MEGA16的串口程序，包含字符串发送及接收程序段-Based AVR MEGA16 serial program, including the string to send and receive blocks
I2C-bus-driver-function
- I2C总线驱动函数,I2C控制总线函数，I2C释放总线函数，I2C数据传输函数-I2C bus driver function