资源列表
0802LCD
- 0802液晶显示：在LCD 屏幕上显示广告词（51单片机控制）-0802 LCD : LCD screen shows the words (51 MCU control)
ssss.rar
- 采用8位LED动态扫描时钟演示程序，使用12MHZ晶振，P0口输出段码，P2口作列扫描，用共阳LED数码管。,Using 8-bit dynamic scanning LED clock demonstration, the use of 12MHZ crystal, P0 port output above code, P2 scan I made out with a total of LED digital tube Yang.
xunji
- 通过8051单片机控制小车循迹，可做90度转弯，简单明了-Car tracking control through 8051, can do 90-degree turns, straightforward
send
- 用C实现信号发生装置：1、正弦波：频率、幅度可调。 2、三角波：频率、幅度可调。 3、方 波：频率、幅度、占空比可调。 4、按键：波形切换、频率调节、幅度调节、方波占空比调节。 5、显示：信号的频率、幅度，在方波时还要显示占空比。 -Implementation using C Signal: 1, sine wave: frequency, amplitude adjustable. 2, triangle-wave: frequency, amplitude adjust
lcd
- 12864专用驱动C程序 有需要的朋友可与我联系-this is my C
fft
- 关于vhdl-FPGA实现fft算法的模块-MATLAB VHDL ADN EDA
5-daojishiyanshi2
- 51单片机汇编程序样例之，05倒计时演示2，分享给大家。-Sample of 51 single-chip assembler, 05 countdown demonstration 2 to others.
zhongduanshumaguan
- 定时中断4位数码管显示，P2口低4位作位选，P1口为段选-Timer interrupt 4 digital tube display, P2, the lower 4 bits for the bit selection, P1 port for the segment selector
[C30PdsPIC30F6014A]
- 这是dsPIC6010A在C30编译器情况下的AD转换的C代码，并且通过了编译！-This is dsPIC6010A AD conversion of the C code in the case of C30 compiler, and by the compiler!
001
- 4wd小车测试程序。小车前进测试程序。仅供参考。-4wd car test program. Car forward test procedures. For reference only.
fly-robot
- 通过手机客户端实现飞行器的平衡，调节涵道风扇发动机-a way to control fly machine
I2C
- 基于单片机的I2C协议程序，可以用，已调试过-Based on SCM I2C protocol program, can be used, it has been commissioning