资源列表
qudong74hc164
- 74hc164的驱动程序,很适用于初学着
ds18b20c
- 温度传感器的读写操作，51单片机上的驱动程序，
TEST_LCD
- TFT液晶屏测试程序，CPU为W77E58，修改发送指令可在液晶屏上显示不同的字符或图形-TFT LCD screen test procedures, CPU W77E58 to amend the directive to be sent on LCD screen show different characters or graphics
key
- avr单片机键盘扫描程序（非矩阵），含连击及长按判断-scanner keyboard avr microcontroller (non-matrix), with batter and press to judge
TLC1543
- TLC1543 10位AD驱动程序的源代码，供参考-TLC1543 10 bit AD driver source code, for reference
1602
- 用1602显示的秒表，支持按键修改成当前时间。-The stopwatch display with 1602, support key changes to the current time.
SCMGTX-lesson9
- 单片机相关例程，郭天祥十天学会单片机第9课例程-SCM related routines, Guo Tianxiang ten days the first lesson learned routines microcontroller
3.3
- 调节舵机使之转动5个角度 0 45 90 135 180 PWM信号周期为20ms。程序流程是：开机时舵机角度自动转为0度，按下 P3.7则转到45度，以后就根据两个按键的按下而转动。控制高电平的持续时间即可控制舵机停止制动的角度，0.5ms-0度 1-45 1.5-90 2-135 2.5-180 。-Adjust the steering gear so that rotation angle of 5 0 45 90 135 180 PWM signal period is 20ms. T
3
- 实验板中高两位和低两位数码管为两个独立计数器，利用键盘的两行按键通过外部中断方式分别控制它们的计数。每行选用三个按键分别作为一个计数器的启动、暂停、清0控制键。-High two and low-experimental board two digital tube into two independent counter, two rows of the keyboard keys by external interrupt, respectively, to control their co
crc
- CRC校验，CRC16，方便的CRC函数，封装好-CRC checksum, CRC16, convenient CRC function, package
main
- 此文件为继电器源代码（keil软件运行）-This file is a relay source code (c51 software running)
24C02
- EEPROM芯片24C02 C语言驱动源程序，可经修改管脚定义直接驱动使用-EEPROM chip 24C02 C language driver source code can be directly drive the use of revised pin definitions