资源列表
JIEKOU
- 单片机与FPGA通信的小程序，做的不好请多指教。谢谢了！这真是个好网站啊-MCU and FPGA communications small programs, please do not enlighten. Thank you! This is a good site ah!
dzz
- 显示缓冲区数组*/ unsigned char clockstr[6] /*时间显示的数码管编码数组*/ unsigned char alartstr[6] /.../*第二次按C键设置分位,第三次按键设置秒位,第四次按键完成退出设置*/ if(SetSelect==0) /*按到第四
led
- 单片机用串口控制LED的C程序。相信大家看了后会有收获的
ADF4360-8
- 单片机控制锁相环芯片adf4360-8产生高频信号的程序。-SCM control phase-locked loop chip adf4360-8 high-frequency signals generated program.
STC98c518051
- 这是一个实现串口通讯,发送与接收的源程序。用最简单的方法进行串口调试-This is a Serial communication, send and receive the source code. The simplest way to use serial port for debugging
UART
- 单片机与PC机通过RS232接口进行串行通信程序-Microcontroller and PC machines through RS232 serial communication interface procedures
24c08
- 此程序可实现51系列单片机的E2PROM的扩展。次24c08程序可实现断电保持功能，可完成读写功能。-This program can be used to read and write.
ADF4360-8
- 单片机控制锁相环芯片adf4360-8产生高频信号的程序。-SCM control phase-locked loop chip adf4360-8 high-frequency signals generated program.
BLDC-control
- 此代码为51单片机驱动电子调速器，控制四路无刷直流电机转速-A program of controlling BLDC with 89C51
step
- 简单的单片机控制步进电机加减速程序，使用分段延时实现-A sample Acceleration and deceleration programing use for MCU，by segmented time-delay
PLL_Init
- 飞思卡尔单片机XDT512初始化文件 PLL模块-Freescale microcontroller XDT512 PLL module initialization file
PCAcapture
- PCA捕捉模块0的CEX0被设置在按键S3对应的引脚上，按下和松开S3，将会产生下降和上升沿信号，引发捕捉模块动作。-PCA Capture Module CEX0 0 is set on the keys S3 corresponding pin, press and release S3, it will have a fall and rising signal, triggering capture module operation.