资源列表
StepM
- 该源程序为8051F020单片机控制步进电机的程序-the source of 8051F020 SCM stepper motor control procedures
51
- LED 点阵控制，可以实现点阵字体显示，根据自己的要求设置
5615
- 是一个5615芯片的驱动程序，5615是一个8位的D/A芯片，用它与51单片机组成的控制系统具有结构简单，性能稳定的特点。-5615 is a chip of the driver, is a 5615 eight of the D / A chips, and use it 51 MCU control system is simple in structure, performance and stability characteristics.
jiaotong
- 用MCS51系列单片机开发的交通灯控制程序-MCS51 series single-chip with the development of the traffic lights control procedures
T2
- T2做为波特率发生器初始化函数 用于串行通信-T2 as a function to initialize the baud rate generator for serial communication
anjianshaomiao
- 这是一个按键扫描程序，按键结果在开发板上显示出来-This is a key scanner, key results are displayed in the development board
stepper-motor
- 步进电机驱动程序：用软件实现仪表步进电机的驱动，采用细分的方法实现电机的控制！-Stepper motor driver: software instrumentation stepper motor drive, motor control method by subdivision!
so12864-14e1
- 集萃电子so12684-14e1屏底层驱动，已在正式产品上使用-Highlights of electronic so12684-14e1 screen underlying driver, official products
duojikongzhi
- MG90舵机控制程序 可以自己调整方波 来控制舵机的偏转-MG90 servo control program can adjust the square wave to control the deflection of the steering gear
51The-time-interrupt
- Trick 须要放在中断函数中，不然会出现线程不同步的现象。 -Trick must be put into the interrupt function, otherwise there will be no thread synchronization.
delay
- 单片机的延时程序，此程序提供毫秒级的延时。-SCM delay program, this program provides millisecond delay.
123
- 用51定时器做的一个数码管计数器，有注释，适合初学者-51 timer using