资源列表
main
- NRF401无线传输模块与51连接使用的发送源代码。使用无误。是最基本的发送代码，易懂，易用。-NRF401 wireless transmission module for use with 51 connections to send the source code. Use correct. Send the code is the most basic, easy to understand, easy to use.
MicrocontrollerusingClanguageinterruptexample
- 单片机用C语言编写中断的范例，请高手指点，学习-thank you
HolePulse
- 模拟霍尔脉冲，一个很简单的脉冲电路，可以添加在信号发生里。-Analog Hole pulse, a very simple pulse circuit can be added in the signal.
Frequency-meter
- 基于51单片机的频率计源程序 在keil3环境下编译 可以拓展为电容，电感和电阻的测量。-51 microcontroller based frequency counter source can be compiled under the keil3 expanded to capacitance, inductance and resistance measurements.
93c46
- 93C46系列EEPROM读写程序，方便单片机，RAM编程-93C46 series EEPROM read and write procedures to facilitate the microcontroller, RAM programming
DA_TLC5615
- TLc5615串行10位DAc,单5V电源工作,3线串行接口与51数据传输,Vpp为2倍基准电压的三角波输出程序-TLc5615 serial 10-bit DAc, single 5V power supply, 3-wire serial interface with 51 data transmission, Vpp to 2 times the reference voltage of the triangle wave output program
ds18b20
- 基于avr的ds18b20的驱动 不足之处大家多多指正-Avr based on the ds18b20 you drive a lot of correcting deficiencies
1234
- TN模组点亮程式，IC：ST7066，很完整。-TN module light program, IC: ST7066, very complete.
chuankou
- 通过串口想单片机发送数据，并将数据显示在数码管上-Microcontroller to send data through the serial port, and the data is displayed on the digital
Main
- AD7151 与单片机MSP430F1XXX 系芯片的I2C通信代码-AD7151-Capacitance to Digital Converter I2C code
MCU44key
- 单片机4*4矩阵键盘检测程序，构思精巧又十分好用-MCU 4* 4 matrix keyboard detection procedures, sophisticated ideas and very easy to use
2
- 对c51单片机的0中断口的c语言初始化设置-0 c51 microcontroller interrupt port c language initialization settings