资源列表
AD421
- 本程序为AD421的开发源代码，进行单片机研发之用，将16为串行数据转换为模拟数据-The program source code for the development of AD421, the microcontroller development purposes, will be 16 for the serial data is converted to analog data
4LQDQ
- 用C语言写的4路抢答器,对单片机入门者可能会有帮助.-Using C language Answer the 4-way, and on the single chip may be helpful to beginners.
decoderesp
- GA3 for single machin problem
1
- 实现时钟程序，要求开始时DS1、DS2显示分钟，DS2的小数点亮，DS3、DS4显示秒，初始时都显示0；运行后DS4每隔一秒钟数字加1，加到10后变为0，DS3加1，DS3、DS4加到60后变为00，DS2加1；DS1、DS2加到60后，切换到小时状态：DS1、DS2显示小时，DS2的小数点亮，DS3、DS4显示分钟，DS4的小数点亮每隔一秒亮灭一次，亮灭分别30次后，DS4加1。-Realization clock procedure, request beginning hour DS1,
TLC1543
- 8051与TL1543构成的数据采集A/D的试验电路-8051 and TL1543 composition data acquisition A/D Test Circuit
11
- 单片机485接受控制DA转换的C程序 用keil变邪恶-DA converter chip 485 to accept control of the C program
avr
- mega16 ad转换参考程序，有详细解释，献给需要的朋友-mega16 ad conversion reference program, explained in detail, dedicated to the needs of friends
rgy
- 红绿灯控制程序，基于stc51系列单片机-Traffic light control program, based stc51 series microcontroller
3
- 单片机开发的C语言程序，用数码管动态显示按键两位数自加-Microcontroller C language program development, digital dynamic display buttons double-digit increase since
Fourier
- 本程序是傅里叶公式的展开计算公式，用于电力电参数的计算-This program is the Fourier formulas expand the formula for the calculation of the power electrical parameters
systick
- lpc1114的系统定时器systick的代码，实现两个led灯的循环亮灭。-system timer systick code lpc1114 achieve two led lights blinking cycle.
readlcdoffset
- Programming for Reading LCD Offset(i.e. Cursor Position )