资源列表
serial(UART)
- source code for Serial (UART) ATmega16
FT1505_LG20_Initial_new
- 1505 IC 的初始化代码，应用于LG2。0+1505 真彩色屏的原代码。-1505 IC initial code ,apply in LG2.4+1505 TFT PANNEL.
lamushixianshijishu
- 拉幕式显示技术.采用八个数码管，其中数码管是共阳极的-La-screen display technology. The use of eight digital tube, which is a total digital tube anode
SCA100T
- 倾角传感器SCA100T的单片机驱动程序，在M128上调试通过-Tilt Sensor SCA100T microcontroller driver debugging via the M128
M147
- 这是MAX147的汇编程序,功能：本程序主要是读出输入通道CH0(或CH1,CH2,到CH8)的模数转换值,转换值放在寄存器R6,R7中,R6放高位。MAX147芯片的8个通道可编程为单极性/双极性和差动/单端工作, 这里采用单端\单极性输入。MAX147有内部时钟和外部时钟两种工作模式,这里采用内部时钟模式-This is the MAX147 s assembler, function: This program is mainly read input channel CH0 (or C
led_1addto100
- 51单片机控制，在数码管上显示1~100的，间隔1秒.-This program is used to display the number from 1 to 100 on a nixie tube, adding 1 per second, which is controlled by 51 MCU.
motorspeed
- 采用单片机89C51控制直流电机运行，在运行过程中可以实时调节电机的转速，代码采用keil c编写-The 89C51 microcontroller to control the operation of the DC motor can adjust the motor speed in real time during operation, code written in keil c
uart
- 51单片机的串口通讯，简明易懂，有详细的注释。-uart for 8051。
KF
- Kalman filtering model built with matlab
ADUC842--DA
- ADUC842 循环法 DA输出缓慢增加-DA output increase slowly ADUC842 loop method
7611
- 51 single on DAC7611 procedures
led_flash
- switch状态机+定时器实现LED灯闪烁多次-switch state machine+ timer, LED flashes repeatedly