资源列表
le7
- 通过单片机控制0832芯片实现数模转换 输出波形-0832 through the single-chip microcomputer to control the number of chip-to-analog converter output waveform
11
- 单片机设计,时钟芯片在单片机系统中的应用设计实例-Single-chip design, the clock chip in the single-chip system design example
umul1608
- SAM88RCRI指令集实现一个无符号16位数与一个8位数相乘的宏-SAM88RCRI instruction set to achieve a median of 16 unsigned 8-digit multiplication with a macro
DS130218B20LCD1602
- DS1302+18B20+LCD1602时钟日期温度显示--三大部分结合，对学习有帮助-DS1302+18 B20+ LCD1602 Clock Date Temperature Display- combines the three most of the study will help
MMC-1
- 这个是09年电子设计大赛时用NEC提供的专用电机驱动芯片MMC-1的驱动程序 已经调通- This is when the Electronic Design Contest in 2009 with the NEC to provide a dedicated motor driver chip MMC-1 drivers have been transferred Pass
4
- 很好的代码，好好学学，关于51单片机开发的独立键盘程序-A very good code, good to learn about the development of an independent 51 MCU Keyboard Program
LABVIEWCVIAT89C51
- LABVIEWCVI和单片机AT89C51之间的程序-LABVIEWCVI and procedures between the MCU AT89C51
signal
- 基于51单片机的低频信号发生器的C语言例程-51 MCU-based low-frequency signal generator of the C language routines
LEDdisplay1
- 动态扫描，即每一时刻，只让一个数码管亮。让数码管从第一个到地第八个依次快速地显示，给人的视觉效果就是八个数码管同时显示。-Dynamic scanning
UARTMesg
- UART message of message
counter
- 单片机应用下的计数器程序，可以用于电机转速（高、低速度）、频率（高、低频率）测量-Counter program, under the SCM application can be used for motor speed (high and low speed), frequency (high and low frequency) measurements
PRINT
- 单片机打印程序，很好用的程序，我用了很多次-SCM printing program, a good procedure, I used a lot of times