资源列表
14DSpexperimenttestprogram
- 学习DSP的一些小程序，有滤波器，信号发生器，指令实验，串行口-A small program, learning DSP has the filter, signal generator, instruction experiment, the serial port, and so on...
Structure-and-principles-of-MCS-5l-
- 详细介绍MCS—51单片机的硬件、软件、接口及其开发与应用技术。- Details MCS-51 microcontroller hardware, software, interfaces, and the development and application of technology.
SPI
- 本程序在IAR环境中运行，其主控芯片是LPC2103,LPC2103支持两个SPI总线接口，通过SPI总线可以传输各种数据，方便，效果好。-The program runs in the IAR environment, the master chip LPC2103, LPC2103 supports two SPI bus interface, SPI bus can be transferred through a variety of data, convenient and effec
sinwave10Hz40MHz
- 正弦信号发生器10Hz~40MHz 编译通过，很有用的-Sinusoidal signal generator 10Hz ~ 40MHz compiled through, very useful
PCBdesign
- 主要讲解pcb制版需要注意的地方，以及pcb设计的相关参数。-Explain the main areas requiring attention pcb plate, and the pcb design parameters.
PCB-design-process
- PCB工艺设计规范 ,初学者应该-PCB design process
r
- 感温 线缆式火灾定位报警控制器的研制-Temperature cable-type fire alarm Controller for Positioning
demoXSSCI
- freestyle mc9s12 sic例子-freestyle mc9s12 sic 例子
KeyBorad
- msp430f149键盘输入控制实践工程实例-msp430f149 keyboard input control practices Project
DS18B20
- DS18B20温度控制程序，精度为0.0625，但是本身开发时用的显示只有4位，显示程序的显示位可调-DS18B20 temperature control procedures, an accuracy of 0.0625, but the display itself developed only four adjustable, the display position of the display program
51TCPIP
- 用51单片机开发的以太网转RS232的电路板资料，包含电路板光绘文件和51单片机的原程序。-Developed with 51 single-chip Ethernet switch board RS232 data, including the circuit board Gerber files and the original program 51 microcontroller.
ExampleCode_ADC_AD7862
- adi公司ad7862C语言驱动程式，经测试可以使使用。程式中采用IO模拟SPI总线方式。-adi' s ad7862C language driver, the test can make use of. Simulation program used in IO SPI bus mode.