资源列表
remote
- nec协议红外遥控的stm32解码程序，基于v3.5-infrared remote control stm32 nec protocol decoding procedure, based on v3.5
Temperature
- 用QT经过串口通过读取单片机的温度数据实现上位机上的图行显示，qt显示温度表盘-By reading through the serial port using QT temperature data to achieve single-chip PC line on the chart display, qt shows the temperature dial
rs232
- PIC16F877A 使用20M晶振，仿真调试通过，可识别指令， 附件含程序和proteus仿真电路-PIC16F877A using 20M crystal, simulation debugging through, recognizable command, annex containing the procedures and proteus simulation circuit
cc2530_SHT11_DHT11
- 基于CC2530的温湿度传感器程序。包括SHT11 和DHT-CC2530 is based on temperature and humidity sensor program. Including SHT11 and DHT11
CZ_PROG
- 工业五线的电阻测量源码，可以精确到0.01欧姆，使用ad7705作为ad器件-Industrial five-wire resistance measurement source, can be accurate to 0.01 ohms, using ad7705 as ad Devices
HT66F50_mirowire-bus-E2PROM
- 用于HT66F50单片机的MicroWire BUS接口E2PROM读写控制实验-MicroWire BUS interface for HT66F50 microcontroller E2PROM read and write control experiment
chaoshengboceju
- 51单片机驱动超声波测距模块进行测距，液晶显示测距数据。-51 single-chip drive ultrasonic rangefinder module for distance measurement, liquid crystal display ranging data.
traffic-light-at-interrupt
- 带中断的交通灯 protues仿真 keil开发环境c-traffic light with interrupt proteus simulation keil C
模拟电梯运行控制
- 利用stc12c5a60s2单片机在液晶屏上实现电梯模式(Using STC12C5A60S2 MCU to realize elevator mode on LCD screen)
KEY_PWM
- stc15单片机 实现红外解码 支持连续检测 通过红外遥控器控制单片机的PWM的频率(Stc15 MCU infrared decoding, support for continuous detection, through infrared remote control microcontroller PWM frequency)
Project._LineChecck
- 使用GPIO检测线序是否正确，电压是否在合理范围内，否则红灯和蜂鸣器报警。(Use GPIO to check line sequence is correct, voltage is within reasonable range, otherwise red light and buzzer alarm.)
数码管显示
- 数码管显示，编程的显示文件，用于初学。便于爱好者理解。(Digital display, programming display files, for beginners. Easy for lovers to understand.)