资源列表
PICMCU_c
- 《PIC单片机C语言开发入门》所有章节源程序，光盘中配套-"PIC C-language development Easy" all the chapters of source files, CD-ROM support
AT89S52+12864+Proteus7
- AT89S52驱动12864液晶的例子+Proteus 7 Professional仿真电路
Program
- AVR自平衡车主程序，使用ENC-03陀螺仪和MMA7260作为传感器，内含卡尔曼滤波、PID-AVR owners of self-balancing process, the use of ENC-03 MMA7260 as gyroscopes and sensors, embedded Kalman filter, PID, etc.
MSP430F149-NRF24L01
- MSP430F149驱动NRF24L01的收发程序-MSP430F149 drive NRF24L01 transceiver procedures
msp430f247
- msp430f247硬件原理图设计开发和应用-msp430f247 hardware schematics and design development and application of
CCC
- 自平衡机器人的驱动程序，用于两轮自平衡机器人-Self-balancing robot program
2635546465
- 此程序为应用51单片机汇编编制的对无线遥控解码芯片PT2262的软件解码，解码程序经测试OK。-This program compiled for the application compiled on 51 single-chip decoder chip PT2262 wireless remote control software decoding, decoding procedure tested OK.
test-serial
- 利用C51编写串口测试程序，借助于虚拟串口，在PROTUES中进行仿真，串口助手中可以接收到单片机发来的数据。-C51 prepared using serial testing procedures, by means of virtual serial ports in PROTUES the simulation, the assistant can receive serial data sent to the microcontroller.
1602-display-51
- STC89C52例程及原理图,公司标准程序，运行无错，包括其中的1602串口显示51参考程序部分-STC89C52 routines and principle diagram, the company s standard procedure, error-free operation, including 1602 serial display 51 reference program
用Proteus 7.2 仿真的51单片机128x64液晶滚屏显示
- 用Proteus 7.2 仿真的51单片机128x64液晶滚屏显示，包括源程序和仿真文件。,Proteus 7.2 Simulation with 51 Singlechip Scroll 128X64 LCD display, including the source code and simulation files.
1234567
- 如图1所示门形支架的一个立柱上用转轴固定一根U型导轨，导轨的另一端可由固定在顶梁上的电机控制其上下运动，使小球在导轨上按要求灵活滚动或移位。导轨以转轴处为原点，以厘米（cm）为单位标注位置（见图中放大部分）-As shown in Figure 1 a column of the portal type bracket with a fixed rotating shaft U-type guide rail and the other end of the guide rail can be
diantikongzhi
- 四层电梯西门子PLC控制程序实例,工业使用-Siemens PLC control four-story elevator instance, industrial use