资源列表
C8051_flash_gb
- 摘 要： 本文件是C8051单片机字库（GB2312）测试实验程序；使用外部22.1184MHz晶振. 功能：定义 0 ~ 3 、 A 、 F 为功能键。按\"A\" 键显示输入位码界面，按 0 键页位置加1，按 1 键字位置加1， 按 2 键页位置减1，按 3 键字位置减1，并在LCD上显示该汉字。按\"F\"返回显示待机界面。-Abstract : This document is C8051 MCU font (GB2312) testing laboratory proc
test_smbus
- c8051单片机使用smbus（I2C）接口的测试程序，keil开发环境
T01
- 51单片机定时器程序编写实例，对于初学者很有帮助。
AVR_ATmega16_Modbus_Example
- 在ATmega16中编写的Modbus测试程序。-Written in the ATmega16 in Modbus test program.
LHB
- Microcontroller-based ward call system. Very simple, using a compilation prepared.-it is a program
lesson1
- 郭天祥10天学会51单片机 课后作业 第一课-Debates about 10 days, 51 MCU learn the first lesson homework
lesson1
- 基于51单片机的C语言设计，主要是流水灯的设计-51 C-based design of single chip
wireless_APC220
- 无线模块apc220，发送接收程序，实测可用，并附使用注意及实测传输延时-Wireless module apc220, sending and receiving process, the measured available, along with attention and measured using the transmission delay
PT2262
- 我看过很多PT2262软件解码程序，都是用定时器测量脉冲宽度。占用系统太多资源。我自己编写的程序不用定时器，不用中断，代码最少。-I have seen many PT2262 software decoding procedures are used to measure the pulse width timer. Take up too much system resources. I have written a program without a timer, do not inter
ledshouyaobang
- 显示棒Last Loaded 显示棒手摇棒-Last Loaded display bar Last Loaded show stick hand stick
1602LCD
- 89C52RC的1602LCD字符静态显示测试程序-89C52RC 1602LCD display
Can_communication
- 基于c8051f040一个多机通讯程序,开发环境keil，用于can总线通讯-Based on more than one machine C8051F040 the communication process, development environment keil, for the can bus communication