资源列表
AUTO
- 实现交流220V市电的定时开关，可编程修改各参数，特殊情况下可强行开关。主要用于控制自助打印机系统。
CANshow
- 基于sja1000以及stc89c51的can单节点通信程序-Based on the sja1000 and can single-node stc89c51 Communication Program
liushuideng
- 单片机入门的是必须练的流水灯功能，汇编和C两个版本，参考一下吧-SCM entry are two versions of the light water feature, assembler and C must be practiced, refer to it
DS1302SHIZHONG
- C语言实现普中51单品机LD1302时钟模块的程序-C language P 51 LD 1302 microcontroller clock module program
keyboard
- 此程序为单片机键盘程序,是简短高效的4*4键盘程度
MSP430F2013_HT1621_01
- HT1621B驱动 能够运用段码LCD-HT1621B drive
Competition
- 湖北省电子设计大赛c题我们的代码，基于430单片机的工程代码-Hubei Electronic Design Contest c question our code 430 microcontroller-based engineering code
12864lcdP51mcu
- 利用51、avr等单片机实现12864液晶屏的读写显示中文源程序，亲自使用验证。-Use 51, avr MCU, such as reading and writing 12864 LCD display Chinese source, personally use authentication.
StepMotor
- 步进电机的程序，里面有几个程序吧~~当然要看你说对应的电机能否与这个型号相符合-Stepper motor program, which has several programs it ~ ~ of course depends on whether you say the motor corresponding consistent with this model
NRF24L01for-MEGA16-test-master
- NRF24L01 模块 for MEGA16 测试程序-NRF24L01for MEGA16 test program master
1602LCD
- LCD1602实现的电子秒表，单片机采用AVR,显示采用液晶显示。-LCD1602 achieve electronic stopwatch, SCM AVR, display with LCD display.
A1
- 一个样品了AVcc A0参照。 / /软件集ADC10SC开始样品和转换——ADC12SC / /自动清除在始新世。ADC12内部振荡器次样品(16 x) / /和转换。在等待LPM0中的Mainloop调用MSP430的拯救力量直到ADC12 / /转换完成,ADC12_ISR将迫使退出LPM0中的Mainloop调用上的 / / reti。如果A0 > 0.5 * AVcc,p3 4集,否则复位。-A single sample is made on A0 with