资源列表
1602-diplaydriver
- 1602液晶显示驱动.内含完整代码,已测试通过-1602 Display Driver,include all code
dds-parallel-control
- 此为AD9850芯片的并行控制程序，此程序可以产生单频信号，输出能够达到40MHZ，具体视电路状态决定-This is the the AD9850 chip parallel control program, this program can generate a single-frequency signal, the output can be achieved 40MHZ, depending on the state of the circuit decision
F5529_W5500_yeelink_V1.0
- 基于MSP430F5529的W5500与yeelink网站通过以太网通信-MSP430F5529 W5500 and yeelink based web site through Ethernet communication
LCD
- 通过SST89E58单片机测量输入电压的大小，并通过LCD显示出来。-By SST89E58 MCU measurement of the input voltage through LCD display.
7289TEST
- 完整的7289驱动程序 按键的移位闪烁消隐等等函数编写-Shift 7289 driver button complete scintillation blanking etc. function
3-FM-1-SOUND
- PIC18F4520点亮蜂鸣器发响程序,适合初学者-PIC18F4520 FAM PROGRAMER
Motor-C
- 基于51单片机的步进电机控制，能实现正反控制，按键控制转速，及3种步进方式的控制-Based on 51 step motor control, can achieve positive and negative controls, buttons control the speed, and ways to control step 3
CAN-USB-_FIRMWARE
- 实现CAN总线的UBS接口，完成了UBS总线与CAN总线的数据传输的转换-CAN bus interface, the UBS, UBS completed the bus and CAN bus data conversion
F2812CAN
- 完成F2812下CAN总线通讯功能开发,包括CAN数据接收和发送-F2812 complete development under the CAN bus communication, including receiving and sending CAN data
5-UART
- 串口通讯，设置波特率、寄存器配置等详尽说明。-UART xiangxi shuo ming
yejing
- 液晶屏的显示设计程序。可能不够完善。请读者自己仔细更改，以便自己需要的-ffs
LCDxianshi
- 在标准系统中的LCD的显示控制，为标准的H文件，使用时直接包含就可以了-In the standard system in the LCD display control, the standard H-file, you can use include a direct